741458

Elkron 80TC1L00133 Manual

62
Zoom out
Zoom in
Previous page
1/248
Next page
DS80TC1L-001 62
3.2.4 Ceiling installation using a ceiling bracket Ref. 80TH5600133 and Power box IP66 Cod. 80PS9200133
Identify the camera installation point and proceed as follows:
• Drill holes according to the type of wall (cement, wood, etc.) and the fastening devices used
• Fasten the connection box to the ceiling.
• Open the Power Box by unscrewing the four screws on the cover corners.
• Insert in the wire grommets all the cables needed for the correct operation of the camera. For outdoor
installations, close hermetically the wire grommets, in order to maintain the IP protection grade.
• Connect the mains power supply to the dedicated terminal pins, but do not power the Power Box until the
installation is completed.
• Connect the RS485 serial line to AA BB terminal pins from the keyboard.
• Connect the alarm sensors cables to the alarm input terminal pins 1 and 8 (for details, see the manual of Power
Box 80PS9200133).
• Connect the video cable from the video device in use (DVR, monitor, etc.) to the female BNC connector placed
inside the box, taking care to put the rubber sheath for the protection of the metallic parts, in order to avoid that
these ones make electrical contact with internal electronic parts.
• Configure the different Power Box dip-switches (for details, see the manual of Power Box 80PS9200133).
• Close again the Power Box with the screws previously removed to open it.
• Fasten the bracket Ref.80TH5600133 to the Power Box with rubber for base of up ring (ref. The picture as
below), taking care to pass the connection cable in the bracket, until it comes out from the opposite side, before
using the three provided screws.
• Insert the connection cable in the threaded pipe, until it comes out from the opposite side.
• Screw tightly the threaded pipe to the bracket, and lock it with one provide screw
• Screw the bushing to the end of the case of the Dome. and lock it with one of two provide screws
… 62 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elkron 80TC1L00133 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elkron 80TC1L00133 in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 5,89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info