Manual Elite Fuoripista (page 26 of 94) (English, German, Dutch, French, Italian, Spanish)

782484

Zoom out

Zoom in

1/94

20_ZERO OFFSET AND POWER METER

FUORIPISTA Bike allows to conduct the Zero of the internal

system of the power meter.

Zero allows to compensate the system offset in order to

always obtain accurate power output values. Use the My

E-Training software/app/device or operate the gear shift

levers to start the Zero function.

In the My E-Training mobile version the Zero command can

be found in: Parameters - Advanced configuration - Home

Trainer calibration.

In the My E-Training desktop version the Zero command

can be found in: Settings - Home Trainer calibration.

FUORIPISTA Bike can conduct the Zero procedure by using

the gear shift levers and not the My E-Training app. Please

check paragraph 26_SERVICE FUNCTIONS FOR THE ZERO

PROCEDURE VIA GEAR SHIFT LEVERS.

The procedure requires to take your feet off the pedals

at zero speed (so stationary flywheel) and conduct the

procedure from mobile device or desktop. After a few

seconds the procedure will notify its successful completion.

The new offset value will be memorised and displayed by

FUORIPISTA Bike.

Please note: the aforementioned Zero procedure can also

be conducted with other software / apps / devices also in

Stand-alone mode (Please check paragraph 26_SERVICE

FUNCTIONS).

21_SADDLE REPLACEMENT

FUORIPISTA Bike saddle can be replaced with other

saddles. Its fastening is compatible with all commercially

available saddles with standard 7mm diameter frame.

To remove the saddle just untighten the seat post nut

completely (Pic. 14). Remove the saddle, replace it with

the chosen one and tighten it back.

22_REPLACING THE SUPPLIED PEDALS

FUORIPISTA Bike supplied pedals can be replaced with

other pedals. Untighten each pedal from its internal side

with a 6mm hex key (Pic. 29) and replace it with the chosen

pedals

23_TAPE REPLACEMENT

FUORIPISTA Bike handlebar tape can be replaced.

FUORIPISTA Bike is not compatible with the commercially

available tapes. FUORIPISTA Bike requires a 2.4 mt long

tape (available on https://www.shopelite-it.com/). To

replace the tape, untighten the upper and lower fastening

(Pic. 30), detach the tape and wrap the new one starting

from below, and continue making sure to leave 3 texture

holes uncovered at each passage. The initial and final

areas must protrude about 3 mm to ensure that they can

be fastened. Lastly, tighten the upper and lower areas.

Please check out www.fuoripista.it for further info.

24_BRAKE PAD REPLACEMENT

During regular use of the FUORIPISTA Bike the brake

felt pad will wear over time. To replace it start the brake

replacement service function (check out paragraph 26_

SERVICE FUNCTIONS) and turn off FUORIPISTA Bike power

supply with the dedicated switch close to the battery (Pic.

10);

- untighten the two screws under the pedals area (Pic.31);

- get the left pedal in horizontal position and raise the

strainer (Pic. 32);

- remove the engine cover plate (Pic. 33);

- untighten the two screws of the felt carrier (Pic. 34);

- remove the felt carrier (Ref. W) and replace it with the

new one;

- position the two screws back with the new felt carrier,

fix the screw without tightening them; while pressing the

felt carrier against the glass flywheel tighten the screws

(Pic. 36);

- put the plate back (Pics. 37);

- lower the strainer (Pics. 38).

- tighten the two lower screws (Pic. 39);

Restart the FUORIPISTA Bike(Pic. 10).

After replacing the brake pad conduct the calibration

procedure (please check paragraph 26_SERVICE

FUNCTIONS).

Please visit www.fuoripista.it for further info.

25_POWER SOURCE

FUORIPISTA Bike features two electronic circuit boards

powered via a lithium battery, rechargeable through its

power supply (Ref. G) (supplied). Connect the power supply

to the grid and the jack on the lower area of FUORIPISTA

Bike (Pic. 40) to recharge the battery.

The recharge icon will be displayed and the power supply

LED light will light up.

A fully discharged battery usually takes about 5 hours to

recharge completely, during which time the LED light on

the power supply will be red and become green once it's

fully recharged.

You can workout up to 8/10 hours with a fully recharged

battery. Battery charge is indicated by the battery icon on

FUORIPISTA Bike screen.

WARNING: do not use battery and/or power supply different

from the ones supplied.

FUORIPISTA Bike is equipped with a lithium battery and

as with all lithium batteries we suggest not to discharge

it completely but to always maintain it with at least 30%

charge for it to have a longer life.

IMPORTANT: the battery might suffer damages and

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Elite Fuoripista in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 9.31 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Elite Fuoripista Manual

Product: