13
• Fit the hood into the hole made, by inserting it
from above , as shown in (Fig. 2).
Secure the hood inside the cabinet, by using the
specic xing brackets provided (Fig.3). Fix the
brackets into the lower side of the hood in such
a way that there is a 2 meter distance between
the bracket lower side and the bottom of the
cabinet mm (Fig.4). This distance will allow to
pull the hood downwards during installation, in
order to make the stainless steel frame perfectly
adhere with the worktop.
Before inserting the screws into the cabinet,
make sure that the appliance is perfectly per-
pendicular with the worktop.
Place the suction unit under the appliance, by
making the downdraft air- outlet coincide with
the motor air-inlet.( FIG. 5 ); connect the two
anges (indicated by the arrows in gure 5) by
means of the pipe supplied with the appliance,
and cut it accordingly to the cabinet height .
The downdraft rear air-outlet (g. 6 ) can be
used only if the cabinet size allows you to do
so; in such a case the rear air-outlet ange
shall be installed after the downdraft has been
installed into the cabinet.
Some examples of installations are given in Fi-
gure 7 and 8
The motor air out-let shall be directed toward
the outside of the cabinet if the appliance is
used in the ltering version, or to the outside of
the house if the appliance is used in the aspira-
tion version.
• Place the metal box containing the electronic
components in an easily reachable area for
possible technical assistance operations, by
connecting the electric connectors of the box to
the hood (g. 14).
• Connect the appliance to the power supply
After opening the glass, as specied in the ‘how
the hood works ‘ section of this manual, you
need to t the grease lters and the charcoal
lters, in case the hood is used in ltering mode,
as well as the aesthetic grid.
Grease lters are mounted as shown in g.11,
placing them inside the appliance until they re-
ach their seat; to remove them, please carry out
the reverse procedure.
Charcoal lters, if necessary, are t before
mounting the grease lters, by following the
same procedure.
After mounting the lters, the aesthetic grid
shall be t into the related housing, see gure
11 and 12. The grid is removed by grabbing it by
the specic knobs shown in gure 12.
How the hood works
In order to operate the appliance, it is necessary
to open the glass by following this procedure:
Push the glass downwards in the front side, as
shown in g. 9; the glass will be released and
will open of about 2 cm,: then the glass shall be
rotated up to a 45° or 90° opening , based on
your needs. (see gure 10).
Following the glass opening, it will be possible
to operate the suction motor by using the push-
button panel as follows: