471195
10
Zoom out
Zoom in
Previous page
1/12
Next page
Instruction on mounting and use
Consult the designs in the front pages referenced in the text
by alphabet letters. Closely follow the instructions set out
in this manual. All responsibility, for any eventual
inconveniences, damages or fires caused by not complying
with the instructions in this manual, is declined.
Use
The hood has been made for use in the internal recirculating
filtering version.
Cooking fumes and steam are aspirated inside the hood,
filtered and cleaned, passing through the fat filter/s and the
carbon filter/s that MUST be supplied with the hood.
Attention!
If the hood is not supplied with carbon filter, then it must
be ordered and mounted.
Installation
The minimum distance between the supporting surface for the
cooking vessels on the hob and the lowest part of the range
hood must be not less than 50cm from electric cookers and
70cm from gas or mixed cookers.If the instructions for
installation for the gas hob specify a greater distance, this
must be adhered to.
Electrical connection
The electrical tension must correspond to the tension noted
on the label placed inside the cooker hood. Connect the
electrical plug, where provided, to the an easily accessible
outlet in conformity with local standards in force. Where an
electrical plug is not provided (for direct connection to
electrical network) place a standards approved bipolar switch
with an aperture distance of not less than 3mm (accessible)
from the contacts.
Attention: substituting the supply cable must be carried out
by the authorised technical assistance service.
Mounting
Expansion wall plugs are provided to secure the hood to most
types of walls/ceilings. However, a qualified technician must
verify suitability of the materials in accordance with the type of
wall/ceiling. The wall/ceiling must be strong enough to take
the weight of the hood. Do not tile, grout or silicone this
appliance to the wall. Surface mounting only.
Description of the hood - Fig. 1
K. Panel of control
L. Halogen bulb
M. Lateral filter holder frame
N. Active carbon filter
O. Metal anti-fat filter
Note: other carbon and anti-fat filters are installed inside
the hood in correspondence with the shaped lateral slots
and the upper part of the hood.
P. Anti-fat and carbon filters holder frame
Q. Filter holder frame releases
Operation
Use the high suction speed in cases of concentrated kitchen
vapours. It is recommended that the cooker hood suction is
switched on for 5 minutes prior to cooking and to leave in
operation during cooking and for another 15 minutes
approximately after terminating cooking.
The hood is equipped with a “TOUCH SENSOR device able
to determine the control of the lights and the speed when the
user touches the control bar. Read the instructions below
carefully for this purpose.
The hood is also supplied with a remote control for controlling
light, speed and other functions (see the paragraph relating to
the functioning of the remote control).
Automatic switch-on function
The hood is equipped with a temperature sensor that starts
the motor at the 1
st
suction speed (power) when the room
temperature around the hood is higher than 70°C.
The user can, however, switch off or modify the suction speed
(power). (See paragraphControl of suction speed
(power)).
Control of suction speed (power)
The selection of the suction speed (power) is cyclical,
according to the speed sequences “”stand-by - 1-2-3-4-
Stand by -1-2-”… so that at every touch of the UPPER PART
of the control bar the suction speed (power) increases by a
level and then to switches off (stand-by) if the control bar is
touched again when the hood is at suction speed (power) 4.
It is possible lo turn the hood off (standby) even when the
hood is at any speed by pressing the UPPER PART of the
control bar (for more than 3 seconds).
It is possible to determine what suction speed (power) the
hood is in when the bar is equipped with a led that changes
colour on the basis of the suction speed (power), as follows:
Hood in stand-by: LED OFF
1
st
suction speed (power) - led GREEN
2
nd
suction speed (power) - led ORANGE (amber)
3
rd
suction speed (power) - led RED
4
th
suction speed (power) - led RED (FLASHING)
Note: the 4
th
suction speed (power) remains on for 5 minutes,
after which the suction motor switches off (Stand-by).
Touched once more, the suction motor switches off (Stand-
by).
Need to wash the anti-fat filter: GREEN led FLASHING
(also read the instructions relating to the use of the remote
control).
Need to wash or replace the carbon filters: ORANGE
(amber) led FLASHING (also read the instructions relating to
the use of the remote control).
Control of the central light
The central light can be switched on and off by touching the
LOWER PART of the control bar BRIEFLY.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elica Platinum at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elica Platinum in the language / languages: English as an attachment in your email.

The manual is 1,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info