649795
15
Zoom out
Zoom in
Previous page
1/120
Next page
15
Operation
Use the high suction speed in cases of concentrated kitchen
vapours. It is recommended that the cooker hood suction is
switched on for 5 minutes prior to cooking and to leave in
operation during cooking and for another 15 minutes
approximately after terminating cooking.
Control panel
The control panel is constituted by a knob and 2 led
• To turn the lights on and off:
Press and release the knob (M) to turn on the lights, press
and release again to turn them off.
• To select the available aspiration speeds:
Turn the knob (M) clockwise to increase aspiration speed and
counterclockwise to decrease it, without switching the hood
off.
The hood is provided with a LED (L1) that can display the
selected aspiration speed based on the colour in which it
lights up:
• No light/Light off:
Suction motor switched off
• Steady green light:
Hood on at power 1 (minimum).
• Steady orange light:
Hood on at power 2 (medium)
. • Steady red light:
Hood on at power 3 (maximum).
• Flashing red light:
Hood on intensive power (lasting 5 minutes, then the hood
automatically switches to power 3).
Filter control device
The hood is equipped with a device that indicates when the
filters (grease or charcoal) must be cleaned or replaced.
Normally, the device that warns when you need to perform
maintenance of the filters is disabled.
To activate it, proceed as follows:
Turn off the hood.
Press the knob for longer than 5 seconds
The LED L2 starts blinking in green; after 2 seconds the LED
L2 will start flashing also in orange: the filter control device is
activated.
L2 Led - grease filter indicator
The LED lights green when the grease filter needs to be
cleaned; this happens about every 40 hours.
Each time the hood is used, check whether the L2 LED is
turned on.
Led L2 - charcoal filter indicator
The LED lights up in orange when the charcoal filter needs to
be cleaned/replaced; this happens about every 160 hours.
Each time the hood is used, check whether the LED L2 is
turned on.
Reset of the filter saturation indicator
After cleaning or replacing the filters, turn on the hood (at any
suction speed) and press the knob for more than 3 seconds:
you will hear an acoustic signal (beep) confirming the reset of
the filter saturation indicator; at this point the LED L2 and the
hood switch off.
In cases when the L2 LED is indicating saturation of the filters,
either of the grease or of the charcoal filter, you must repeat
the reset operation.
Maintenance
ATTENTION! Before performing any maintenance operation,
isolate the hood from the electrical supply by switching off at
the connector and removing the connector fuse.
Or if the appliance has been connected through a plug and
socket, then the plug must be removed from the socket.
Cleaning
The cooker hood should be cleaned regularly (at least with the
same frequency with which you carry out maintenance of the
fat filters) internally and externally. Clean using the cloth
dampened with neutral liquid detergent. Do not use abrasive
products. DO NOT USE ALCOHOL!
WARNING: Failure to carry out the basic cleaning
recommendations of the cooker hood and replacement of the
filters may cause fire risks.
Therefore, we recommend observing these instructions.
The manufacturer declines all responsibility for any damage to
the motor or any fire damage linked to inappropriate
maintenance or failure to observe the above safety
recommendations.
Panel
Fig. 20-21-22-23
Clean the perimeter aspiration panel with the same frequency
as the ant-fats filter, using a cloth and not too concentrated
liquid detergent. Do not use abrasive substances.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elica Filo at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elica Filo in the language / languages: All languages as an attachment in your email.

The manual is 7,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info