471238

Elica ELISLIM Manual

4
Zoom out
Zoom in
Previous page
1/5
Next page
Introduction to the Hood - Fig. 1
1. Light Switch
2. Motor Speed Switch
3. Light Covers - illumination of the Cooking
Surface
4. Grease Filters
5. Grease Filter Support Grate (the grease
filters are located within).
6. Light Cover Supports
7. Pull-Out Drawer
Model with Self-supporting Metal
Filters
Removing the Grease Filters - Fig. 2
a. Remove the pull-out drawer completely.
b. Press the side handles (A) towards the
opposite side and remove the filters.
Putting the Filters Back in Place
a. Remove the pull-out drawer completely
and mount the grease filter so that it
covers the drawer.
b. Close the drawer and install the remaining
grease filter.
Opening the Light Cover Support
a. Remove the pull-out drawer completely.
b. Push the B knobs inwards toward each
other (in the “Open” direction as indicated
on the plastic knob itself).
Model with Grease Filter Support
Grate
Opening the Grease Filter Support Grates
- Fig. 3
a. Remove the pull-out drawer completely.
b. Push the B knobs inwards toward each
other (in the “Open” direction as indicated
on the plastic knob itself).
c. To remove the grates completely, use
the N spring fasteners, which act as pins
to hold the grate in place (Fig. 4).
Systems Available
Two systems are available:
Venting Outdoors
The air is vented outdoors through a duct
which must be connected to the exhaust
opening (C - Fig. 5) by means of the flange
(D). The diameter of the exhaust duct must
be exactly the same as that of the flange.
Air Recirculation
— The air is cleaned by means of charcoal
filters (one or two depending on the
model) and then circulated back into the
room.
— The use of a charcoal filter is necessary
when the hood cannot vented outdoors
either because ducting is not available or
cannot be installed.
— The filtered air is returned from atop the
cabinet through a duct that passes
through the cabinet itself.The diameter
of the duct must be the same as that of
flange D (Fig. 5).
The installion (or removal) steps are identical
for hoods with either 1 or 2 motors:
a. Request a charcoal filter from the retailer,
specifying the model and type of hood (1
filter for a hood with one motor and 2
filters for a hood with 2 motors).
Caution! Some charcoal filters come
covered with a plastic film to protect their
filtering properties. If this is the case, remove
the film before installing the filter.
b. Remove the pull-out drawer completely.
c. Remove the grease filters or the grates.
d. Open the light cover support.
e. Install the charcoal filter so that it covers
the plastic grate which protects the
ventilation fan (Fig. 6).
f. Turn the center handle in the clockwise
direction until it locks in place.
g. Remount the grease filters and the grates.
Installation
When installed, the distance between the
hood and burners must be not less than 65
cm for electric burners or 70 cm for gas or
mixed-fuel burners.
Do not tile, grout or silicone this appliance
to the wall. Surface mounting only.
Do not fix chimney flue to furniture or fly over
shelves unless the chimney flue can be
easily removed, in case maintenance is
ever required.
GB
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elica ELISLIM at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elica ELISLIM in the language / languages: English as an attachment in your email.

The manual is 2,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info