784560
19
Zoom out
Zoom in
Previous page
1/164
Next page
19
Mounting
Before beginning installation:
Check that the product purchased is of a suitable size for the
chosen installation area.
Remove the charcoal (*) filter/s if supplied (see also relative
paragraph). This/these is/are to be mounted only if you want
lo use the hood in the filtering version.
Check (for transport reasons) that there is no other supplied
material inside the hood (e.g. packets with screws (*),
guarantees (*), etc.), eventually removing them and keeping
them.
In the case of the presence of panels and/or walls and/or lateral
wall units check that there is sufficient space to install the hood and
that access to the command panel is easy.
Operation
The hood has been designed in such a way as to prevent the
formation of condensation on its lower surfaces when it is placed
on top of an induction hob.
Unlike gas or electric hobs, induction hobs only heat the food
containers and not the surrounding air, so the surfaces of the hood
are cold.
When the hot cooking gases rise, they encounter the cold surfaces
of the hood, which then condense and release the moisture
present in the air that rapidly turns into water droplets. These then
fall onto the hob itself and onto the food, contaminating it with fat
and impurities.
To prevent this from occurring, all the lower surfaces of the hood
are heated by a system of internal resistances that are invisible.
This means that the heating of the lower surfaces of the hood,
even without switching on the hob below, is perfectly normal and is
not a sign of a product malfunction.
The internal grease filter is not specifically heated to condense a
large part of the moisture present in the air. Some drops will,
therefore, form on this surface that will be collected in a special
tray.
Tips and requirements for optimal use of the NO DRIP
SYSTEM
The hood should be switched on a few minutes before
cooking to allow the lower surfaces to warm up and should be
kept on until the odours disappear.
The grease filters should not be removed once cooking has
terminated to allow time for the collected condensation in the
grease filter to settle in the tray.
The rate of condensation collection increases with increasing
suction speed (power).
The NO DRIP SYSTEM offers the best performance in an
environment with a temperature between 18°C and 25°C.
Always open the steam collector (panel) to its full range of
motion.
Motor OFF button (Stand by)
Speed selection button (Suction
power) low
Speed selection button (Suction
power) medium
Speed selection button (Suction
power) high and intensive.
Push to enable high speed (suction
power).
Press again to enable Intensive speed
(suction power) (button will flash for 5
minutes and then return to medium
speed (suction power).
ON/OFF light button
Short press to switch illumination of the
cooking hob on or off.
Long press to switch ambient light on or
off (only on some models).
"Anti-condensation" ON/OFF button:
used to prevent condensation from
forming on the surface of the hood.
Enable when required.
"Automatic anti-condensation":
enabled by the hood each time it is
switched on.
Automatic ON/OFF: with the hood off,
press the button for 5 seconds until the
steady LED is displayed for 3 seconds
(and a beep if available) to ENABLE.
With the hood off, press the button for 5
seconds until the LED FLASHES for 3
seconds (and a beep if available) to
DISABLE.
Note: Anti-condensation is only
enabled only with the motor on.
Caution! Even if anti-condensation is
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elica BOXIN NO DRIP - 60 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elica BOXIN NO DRIP - 60 in the language / languages: All languages as an attachment in your email.

The manual is 2.81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info