658053
11
Zoom out
Zoom in
Previous page
1/14
Next page
4.2 Weld Flaws and possible Causes - Shown on Fillet Welds
21
Attach earth clamp as close as possible to the weld. Structural components, beams, pipes or rails should not be used
for earth conducting if they are not the actual work piece.
Replace broken insulating parts at once!
Clean work piece surface for good conduction
Ring tongue terminal soldered, crimped, clamped
Insulate screw joint terminal with rubber bush or heat-
shrinkable sleeve
Fully Insulated Electrode Holder Connection of Welding Cables to the Work Piece
5 Accessories and Accessory Maintenance
Connecting Welding Cables to the Welding
Power Source
Connecting (Extending) Welding Cables
Weld Undercut
Welding current to high
Electrode work angle too steep
Arc too long
End Crater
Electrode removed too quickly
from the weld pool, particularly
with high welding currents risk
of shrinkage cracking
Weld Toe Cracks
Material sensitive to welding
conditions
Weld cooled down too fast after
welding
Slag Inclusion
Welding current too low
Welding speed to high
Welding over slag on multi-
layer welds
Gas Inclusion
Work surface not clean
(rust, grease, paint)
Arc to long
Basic coated electrodes not
sufficiently dried
Root Flaw
Slag entering root area
because distance too great
handle
spring
insulated jaws
hand lever
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elektra Beckum MAG 160 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elektra Beckum MAG 160 in the language / languages: English as an attachment in your email.

The manual is 0,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info