447062
6
Zoom out
Zoom in
Previous page
1/79
Next page
Using Turbo nozzle 5540
Precautions: Only use nozzle on carpets with a pile depth
under 15 mm. Do not use on animal skins or rugs with long
fringes. To avoid damaging your carpet, do not keep nozzle
stationary whilst brush is rotating. Do not pass nozzle over
mains cable and switch off nozzle immediately after use.
14
Attach turbo nozzle 5540 to tubes.
15
Note: Suction can also be regulated on turbo nozzle by
opening/closing air vent 5540.
Cleaning Turbo nozzle 5540
16
Disconnect from mains and remove entangled threads from
brush by snipping threads with scissors. Open cover to
remove any debris from inside nozzle.
Dust bag indicator and changing the dust bag
The dust bag should be changed when full.
5505/10/15/20/22/25/28 the dust bag indicator window will
turn red when filling and completely red when full.
5530/33/35/36/40 the dust bag indicator window will light up
when full. If the dust bag should accidentally get broken in the
cleaner, take cleaner to Electrolux Service Centre for cleaning.
To check the dust bag, the cleaner must be switched on,
with all attachments connected and off the floor.
The dust bag full indicator may signify that the bag is blocked
(occasionally caused by very fine dust) which will cause loss of
suction and may result in overheating. If this occurs change
the dust bag even if it is not full.
To change the dust bag:
A) Open the cleaner cover.
B) Pull the sliding tab to remove the dust bag.
C) Insert new dust bag by sliding the bag slots into the holder.
Close cover.
We recommend the dust bag is changed:
*
after using a carpet cleaning powder
*
if there is a bad smell from the cleaner, then you should also
change/clean the filter
Note: Use only Electrolux original dust bags (ref.E54A)
and filters:
Micro filter (ref. EF17)
Washable, reusable HEPA filter (ref. EF25a)
Dust bag safety device
To avoid damaging the cleaner, do not use it without a dust
bag. A safety device is fitted which prevents the cover closing
without a dust bag. Do not attempt to force cover shut.
Changing/Cleaning the filters
Never use the cleaner without the filters in place. The Motor
Protection filter should be changed twice a year for normal usage.
To change Motor Protection filter:
D) Open the cleaner cover.
E) Remove filter and covering strip.
F) Important: Insert new filter with original covering strip
securely in place. Close cover.
4
5
6
The Micro filter 5510/15/20/25/28 should be changed every
fifth dust bag.
To change Micro filter:
G) Open the filter cover.
H) Replace filter and close cover ensuring it is properly fastened.
The HEPA filter should be cleaned when the indicator light is
on
5530/33/35/36/40 or every fifth dust bag 5522.
To clean the HEPA filter:
I) Open the filter cover and remove filter unit.
J) Rinse the inside (dirty side) of the filter unit under warm tap
water only.
Do not use cleaning agents and avoid
touching the delicate filter surface.
Tap the filter frame
to remove excess water. Repeat cleaning procedure four
times and allow the filter to air dry. The original filtering
performance is now restored. Replace the unit back into the
cleaner and close cover ensuring it is properly fastened.
Troubleshooting
1. Power: If the electric power does not come on, disconnect
from mains and check plugs, cable and fuses where appropriate.
2. Blockage/dirty filters: The cleaner may switch itself off in
event of severe blockage or excessively dirty filters (on
5530/33/35/36/40 overheat indicator will flash). In such
cases, disconnect from mains and allow to cool for 30 minutes.
Clear blockage and/or replace filter(s) and restart.
The clearing of blocked hoses is not covered by the guarantee.
To avoid blockages and maintain suction efficiency, the floor
nozzles should be cleaned regularly using the hose handle.
Please see additional Electrolux information towards the back
of this booklet.
3. Water: If water is sucked into the cleaner the motor must be
changed at an Electrolux Service Centre.
If you have any comments on the cleaner or the Instruction for
Use Booklet please e-mail us on: floorcare@electrolux.se
2
For healthier homes
ANY PROBLEMS?
08706 055 055
CUSTOMER HELPLINE
for the UK
DON’T TAKE
Something missing?
Don’t understand the instructions?
We are only a telephone call away.
Need more help?
IT BACK TO THE SHOP
Local call cost Australia wide: 1300 369 333
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Electrolux Z 5533 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Electrolux Z 5533 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 5,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info