44268
2
Zoom out
Zoom in
Previous page
1/2
Next page
Lighting the burner (see fig.2).
1. See that the voltage selector switch (7) is set at '0', i.e. is at its central (off) position.
2. Turn on the valve of the gas bottle and open any gas taps in the supply pipe to the refrigerator.
3. Turn the knob (5) of the gas control valve so that the indicator mark is opposite setting No.3.
4. Switch on the ignition switch (4) by pushing in the bottom of the switch against the symbol 'I'. The neon light in the switch should start
flashing indicating that sparking is taking place.
5. Push in fully the knob (5) of the gas control valve and keep it held in. When the burner lights, the neon in the
switch will stop flashing and go out When this happens, keep the knob (5) held in for a further 15 seconds or so for the thermocouple
over the burner to heat up, then release the knob. If the neon starts flashing again, it indicates that the flame has gone out, in which
case, repeat operation No.5.
6. After lighting the burner, leave the switch (4) in the 'On' position.
Refer to the separate Instructions for Use supplied regarding general use and care of the refrigerator.
Emergency Lighting Procedure
Although the refrigerator ignition system is primarily designed to operate from a 12V car battery, it will, in practice, operate satisfactorily on
d.c. voltages considerably below this. If, therefore, the situation arises where the recommended battery supply fails, the burner can, in an
emergency, be lit by using a 9V dry cell (e.g. type PP3 or PP7 9V battery, as used for radios etc.). If doing this, it is essential that the
correct "+" and "-" polarity is observed when connecting up, otherwise the igniter will not operate.
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Electrolux RM212 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Electrolux RM212 in the language / languages: English as an attachment in your email.

The manual is 0,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Electrolux RM212

Electrolux RM212 User Manual - English - 5 pages

Electrolux RM212 User Manual - German - 6 pages

Electrolux RM212 User Manual - French - 5 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info