1230

Electrolux RM 4400 Manual

7
Zoom out
Zoom in
Previous page
1/10
Next page
T
he gas installation should only be carried out by an
a
uthorised gas fitter.
T
he supply pipe should preferably be of copper. If any other
m
aterial is used, it must be of a type approved for use with
c
ontinuously operating bottled- gas appliances, and have
t
hreaded compression connections throughout. PUSH-ON
C
ONNECTIONS MUST NOT BE USED (We do not
a
pprove the use of "rubber" type flexible tubing for connec-
t
ing permanently operating appliances of this type in the
U
nited Kingdom). All connectors etc. should be of a type
s
pecifically designed for the type and diameter of the con-
n
ection pipe used, and screwed joints should be sealed with
a
joining compound approved for use with bottled gas.
T
he gas supply pipe should be connected to the gas inlet
p
ipe on the right hand side of the gas control valve by
m
eans of a suitable threaded compression coupling.
I
n making the connection to the refrigerator, a gas cock of
a
n approved type for use on LPG must be incorporated in
t
he supply line in a position which is readily accessible to
t
he user. For eventual servicing purposes, the union should
b
e on the outlet side of the cock and the pipework should
b
e positioned so as not to prevent the refrigerator from
b
eing readily withdrawn.
E
LECTRICAL CONNECTION
T
he electrical installation must be carried out in a proper
a
nd durable manner, taking into account all relevant regula-
t
ions and codes of practice. For mains voltage operation, it
i
s important that the circuit to and in the caravan is effec-
t
ively earthed. ALL MAINS VOLTAGE WIRING IN THE
C
ARA-VAN MUST BE INSTALLED IN ACCORDANCE
W
ITH CURRENT I.E.E. REGULATIONS INCLUDING THE
U
SE OF AN OUTLET AND COUPLER TO BS4343/-
C
EE17.
F
or connection to a 230 V electricity supply, the refrige-rator
h
as a 3-core mains lead which is intended for connection to
a
properly earthed plug and socket outlet or fused spur.
I
MPORTANT: The wires in the mains lead of this appliance
a
re coloured in accordance with the following code:
G
REEN-AND-YELLOW = EARTH
B
LUE = NEUTRAL
B
ROWN = LIVE
A
s the colours of the wires may not correspond with the
c
oloured markings identifying the terminals in your plug, in
t
he United Kingdom, proceed as follows:
T
he wire which is coloured GREEN-AND-YELLOW must be
c
onnected to the terminal in the plug which is marked with
t
he letter E or by the earth symbol
o
r coloured green or green-and-
y
ellow.
T
he wire which is coloured BLUE must be connected to the
t
erminal which is marked with the letter N or coloured black.
T
he wire which is coloured BROWN must be connected to
t
he terminal which is marked with the letter L or coloured
r
ed.
WARNING! THIS APPLIANCE MUST BE EARTHED.
I
n the United Kingdom, the plug or circuit to the refrige-rator
m
ust be fitted with a fuse not greater than 5 amps. If a 13
a
mp.(B.S.1363) fused plug is used, it should be fitted with a
3
amp. fuse. In other countries, the fuse rating will depend
u
pon the voltage and local practice.
2
30 V Supplies.
C
heck that the voltage stated on the data plate is the same
a
s the mains voltage in use (230 V).
1
2 V Supplies
C
onnect the refrigerator to the vehicle battery by a direct
c
able. To avoid a voltage drop, the cross sectional area of
t
he connecting cable between battery and refrigerator must
b
e at least 2.5 mm
2
if the distance is less than 9 meters,
a
nd at least 4 mm
2
if the distance is more than 9 meters
T
o ensure satisfactory operation, the positive lead must be
f
itted with a fuse rated at max. 16 A.
T
o prevent the refrigerator from draining the battery, make
s
ure that the current supplied to the caravan is cut off when
t
he vehicle engine is not running, for example by fitting an
i
gnition control relay.
Diagramme for the mains installation: fig. 9
Diagramme for the 12 V installation:
fig. 10 (RM 4400), fig. 12 (RM 4401)
T
he notations in the wiring diagramme are:
A. Electronic igniter/reigniter
B. Electrode (at burner)
C. 12 V heating element
D. Switch for 12 V operation
E. Switch for reigniter (gas op.)
F. Electric thermostat
G. Heating element, 230 V
H. Switch for 230 V operation
J. Terminal block
L. Terminal block
1
2 V supply of reigniter (RM 4401)
F
ig. 12 shows the wiring diagramme of the refrigerator as
d
elivered. The 12 V supply enters at (L). The reigniter (A) is
f
ed via two wires (1) and (2) at terminal block (L).
I
t is advisable to feed the reigniter and the lighting from a
s
eparate 12 V source. To do this: remove the wires (1) and
(
2) and connect the supply as is shown in fig. 11.
I
n some executions there in an extra terminal block (J), of
f
ig. 12. In this case one disconnects the wires as said above
b
ut connects the separate supply to (J).
T
he reigniter should not be connected directly to a battery
c
harger but only over a battery.
Electrical leads must be routed and secured so that
they cannot come into contact with hot or sharp parts
of the refrigerator.
12
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Electrolux RM 4400 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Electrolux RM 4400 in the language / languages: English as an attachment in your email.

The manual is 0,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Electrolux RM 4400

Electrolux RM 4400 User Manual - German - 10 pages

Electrolux RM 4400 User Manual - Dutch - 10 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info