Manual Electrolux RM 122F (page 8 of 16) (English)

625959

Zoom out

Zoom in

1/16

When the opening has been made in the caravan wall, the extension

tube (F) may need to be shortened to suit the particular installation. To

determine if this is necessary, fit the flue top (G) to the top of the

central tube of the boiler casing and secure it by means of the screw

(H).

Place the refrigerator into position, then insert the free end of the

extension tube through the wall of the caravan and over the outlet of

the flue-top as far as it will go. Measure the length 'X' (fig. 9) of any

tube protruding from the outside. Transfer this measurement to the

other end of the tube as shown at 'Y' (fig. 9) and cut at right angles

through the tube at this point to shorten the tube to the correct length.

Note 1. If the caravan wall is not vertical or is contoured in the vicinity of the flue outlet, it may be

necessary to make a packing piece from metal or other non-combustible material, of a suitable shape to

ensure that, when in position, the plate on the flue outlet is parallel with the back of the refrigerator.

Note 2. It is not advisable to lengthen the flue venting arrangement for more than a short distance as this

may result in the flue gasses becoming prematurely cooled and water vapour (which is produced during

the natural process of combustion) condensing in the flue and running back into the boiler insulation and

burner.

At this stage, refer to items 10 and 11 in order to prepare for the 12V and

bottled gas connections. When these have been made, before finally

positioning the flue extension tube (F), ensure that the portion passing

through the wall of the vehicle is surrounded by non-combustible material

as shown in fig. 7.

Use a 'soft sealing compound between the flange of the flue outlet and the

wall of the caravan to prevent ingress of rain water.

Fit the outer cover (8) by means of 4 screws.

It will be necessary to remove the outer cover and withdraw the extension tube before the refrigerator can

be moved out of position at any time.

10. ELECTRICAL INSTALLATION

On model RM123, the boiler of the cooling unit is fitted with

two separate heaters, rated at 75W, for use on 230V a.c.

mains electricity, and the 12V battery in the car when the

caravan is on tow.

Model RM 122 does not have a 230V heater fitted.

The electrical installation must be carried out in a

proper and durable manner, taking into account all relevant

regulations and codes of practice. For mains voltage

operation, it is important that the circuit to and in the

caravan is effectively earthed. All mains voltage Wiring in

the caravan must be installed in accordance with current

IEE Regulations including the use of an outlet and coupler

to BS 4343/CEE 17.

a) Wiring for Electronic Igniter (where fitted)

The electronic igniter for the gas burner is for permanent

connection to a 12V d.c. supply, e.g. a car battery.

In a motor-van, the igniter can be connected directly to the

vehicle's main battery or to an existing 12V circuit in the

vehicle which will remain on continuously and will not be

switched off when the engine is switched off. In a caravan,

in order to maintain the supply when the towing vehicle is

unhitched, the igniter must be connected to an auxiliary battery in the caravan. The current drain of the

igniter is negligible therefore the battery can be one that is also used for operating other equipment in the

caravan such as the water pump, lights, etc.

Connect the igniter terminal block (fig. 11) to the battery, ensuring that correct polarity is observed - the

terminals marked'+' and'-'must be connected to the similarly marked terminals of the battery. The wire

used for connecting should be at least 0.5mm2 in cross-sectional area and a 0.5 or 1.0 amp inline fuse

should be fitted in the feed wire, as near to the battery as possible.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Electrolux RM 122F in the language / languages: English as an attachment in your email.

The manual is 0,76 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Electrolux RM 122F Manual

Product: