Manual Electrolux ewt 9120 w (page 7 of 12) (English)

310486

Zoom out

Zoom in

1/12

Operating Problems

Numerous checks were carried out on your appli-

ance before it left the factory. However, should you

notice a malfunction, please refer to the sections

below before contacting the after-sales service.

Problems Causes

The washing machine

doesn’t start or doesn’t

fill:

• the appliance isn’t plugged in correctly, the electrical installation isn’t

working, there is a power failure,

• the lid of your appliance and the drum shutters aren’t closed firmly,

• the programme start command hasn’t been properly selected,

• the water supply has been cut off, the water inlet tap is closed,

• the water inlet filters are dirty,

• a red tab appears on the water inlet hose.

The appliance fills but

empties straight away:

• the drainage U-piece is fixed too low (see installation section).

The washing machine

doesn’t rinse or doesn’t

empty:

• the drain hose is blocked or bent,

• the object trap is obstructed,

• the out of balance detector has been activated : washing is unevenly

distributed in the drum,

• the “Drain” programme or “Night Silence Plus” or “Rinse hold” option

have been selected,

• the height of the drainage U-piece is unsuitable.

You have found water

around the washing ma-

chine:

• too much detergent has caused foam to overflow,

• the detergent is unsuitable for machine washing,

• the drainage U-piece isn’t attached correctly,

• the water inlet hose is leaking.

Wash is unsatisfactory: • the detergent is unsuitable for machine washing,

• there is too much washing in the drum,

• the wash cycle is unsuitable,

• there isn’t enough detergent.

The appliance vibrates, is

noisy:

• all packaging have not been removed from the appliance (see installation

section),

• the appliance isn’t level and is unbalanced,

• the appliance is too close to the wall or furniture,

• washing is unevenly distributed in the drum, the load is too small,

• the appliance is in running in period.

The wash cycle is much

too long:

• the water inlet filters are dirty,

• the power or water supply has been cut off,

• the motor overheating detector has been activated,

• the water inlet temperature is lower than usual,

• the foam detection security system has been activated (too much de-

tergent) and the washing machine has begun draining the foam,

• the out of balance detector has been activated: an extra phase has been

added to distribute washing more evenly in the drum.

The washing machine

stops during a wash cy-

cle:

• the water or electricity supply is defective,

• a Rinse hold has been selected,

• the drum shutters are open.

The lid doesn’t open at

the end of the cycle:

• the temperature inside the drum is too high,

• the lid unlocks 1 - 2 minutes after the end of the cycle.

Softener runs directly into

the drum when filling the

dispenser box:

• you have gone past the MAX indicator.

electrolux 7

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Electrolux ewt 9120 w in the language / languages: English as an attachment in your email.

The manual is 2,23 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Electrolux ewt 9120 w Manual

Product: