- 18 -
Installation
Levelling the machine
The machine must be installed on a sound and
firm surface and must not be touching walls or
furniture. Adjust the feet to level the machine.
Make sure the machine is resting on all four
feet (Fig. 1).
Some vibration is normal and unavoidable when
the machine is spinning the load, particularly if
the floor is not a concrete one.
When the appliance location is on
carpet floors, attention must be paid
so as to ensure that there is no
obstruction to the bottom vents.
Water inlet
Connect the inlet hose to a tap with a 3/4" pipe
thread. If necessary, use the restrictor (1/2”)
supplied (Fig. 2).
The inlet hose must not be joined onto any form
of extension hose. If it is too short, the entire hose
must be replaced with a longer high-pressure
hose, specially designed for the purpose.
The machine end of this hose can be turned in
any direction. Loosen the retaining nut, turn the
hose, then retighten the nut (Fig. 3).
Check that the nut is tightend before
the machine is moved into position.
Use only the inlet hose supplied with
the machine, do not reuse the old inlet
hose.
3
2
1
