7
Transit devices
All transit bolts and packing must be removed
before using the appliance.
You are advised to keep all transit devices so that
they can be refitted if the machine ever has to be
transported again.
1. Using a spanner, unscrew and remove the rear
right-hand bolt.
2. Lay the machine on its back, taking care not to
squash the hoses. This can be avoided by placing
one of the corner packing pieces between the
machine and the floor.
3. Remove the polystyrene blocks from the underside
of the machine.
4. Release the two plastic bags by removing the
adhesive strip.
Carefully remove the right-hand bag (1) then the
left-hand bag (2) by pulling them towards the
centre of the machine.
5. Set the machine upright and remove the two
remaining bolts from the back.
6. Pull out the three plastic pegs from the holes into
which the bolts were fitted.
7. Plug the open holes with the plugs which you will
find on the back of the machine.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that the
machine does not touch the wall or other kitchen
units.
Carefully level by screwing the adjustable feet in or
out. Never place cardboard, wood or similar materials
under the machine to compensate for any unevenness
in the floor.
ENGLISH
Installation
