127575
41
Zoom out
Zoom in
Previous page
1/104
Next page
2. Close the appliance door, the countdown
starts automatically. The number in the
display is no longer flashing but fixed with
static light.
3. The countdown will decrease with steps
of 1 hour.
4. The opening of the door will interrupt the
countdown. Close the door; the count-
down will continue from the point at
which it was interrupted.
5. Once the delay start has elapsed the pro-
gramme will start automatically.
The selection of the washing pro-
gramme and delay start can occur also
with the door closed.
When you press a programme button
you have ONLY 3 seconds to select a
different programme or a delay start.
After these 3 seconds, the selected pro-
gramme starts automatically.
Warning! Interrupt or cancel a washing
programme in progress ONLY if it's
absolutely necessary.
Attention! Hot steam may escape when
the door is opened. Open the door care-
fully.
Interrupt a washing programme in
progress
Open the appliance door. The programme
will stop. Close the door, the programme
will start from the point at which it was in-
terrupted.
Press the on/off button, all indicator lights
will go off. Press the on/off button again,
the programme will start from the point at
which it was interrupted.
Cancel a delay start or a washing
programme in progress
Press and hold the cancel button, until all
the programme indicator lights come on.
If you cancel a delay start also the washing
programme and options (except Multitab)
will be cancelled. Select the washing pro-
gramme again.
If a new washing programme is to be se-
lected, check that there is detergent in the
detergent dispenser.
End of the washing programme
The appliance stops automatically.
The light of the programme just ended re-
mains on.
Zero appears in the digital display.
1. Switch off the appliance.
2. Open the appliance door, leave it ajar and
wait a few minutes before removing the
dishes. This way they will be cooler and
the drying will be improved.
If the save energy function is set, dishes
can be wet once the programme has
finished. We recommend to leave the
appliance door ajar so that dishes can
dry naturally.
Standby mode
If you do not switch off the appliance at the
end of the washing programme, the appli-
ance automatically goes into standby mode.
The standby mode decreases energy con-
sumption.
Three minutes after the end of the pro-
gramme, all indicator lights go off and the
digital display shows one horizontal bar.
Press one of the buttons (not the on/off but-
ton), to go back to end-of-programme mode.
Unloading the dishwasher
Hot dishes are sensitive to knocks. The
dishes should therefore be allowed to cool
down before removing from the appliance.
•Empty the lower basket first and then the
upper one; this will avoid water dripping
from the upper basket onto the dishes in
the lower one.
Water may appear on the sides and the
door of the dishwasher as the stainless
steel will eventually become cooler than
the dishes.
electrolux 41
41


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Electrolux esi 67010 x at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Electrolux esi 67010 x in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 13,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info