345509

Electrolux erb 2436 Manual

16
Zoom out
Zoom in
Previous page
1/32
Next page
16
Defrosting
Frost is automatically eliminated from the evaporator
of the refrigerator compartment every time the motor
compressor stops, during normal use. The defrost
water drains out through a trough into a special
container at the back of the appliance, over the
motor compressor, where it evaporates.
It is important to periodically clean the defrost
water drain hole in the middle of the refrigerator
compartment channel to prevent the water
overflowing and dripping onto the food inside.
Use the special cleaner provided, which you will
find already inserted into the drain hole.
The freezer compartment, however, will become
progressively covered with frost. This should be
removed with the special plastic scraper provided,
whenever the thickness of the frost exceeds 4 mm.
During this operation it is not necessary to switch off
the power supply or to remove the foodstuffs.
However, when the ice becomes very thick on the
inner liner, complete defrosting should be carried out
as follows:
1. pull out the plug from the wall socket or turn the
thermostat knob to the «O» setting;
2. remove any stored food, wrap it in several layers
of newspaper and put it in a cool place;
3. leave the door open, and insert the plastic
scraper in the appropriate seating at the bottom
centre, placing a basin underneath to collect the
defrost water.
4. when defrosting is completed, dry the interior
thoroughly; keep the scraper for future use;
5. turn the thermostat knob back to the required
setting or replace the plug in the power socket.
6. After two or three hours, reload the previously
removed food into the compartment.
Important:
Never use sharp metal tools to scrape off frost
from the evaporator as you could damage it.
Do not use a maechanical device or any artificial
D037
D068
means to speed up the thawing process other
than those recommended by the manufacturer.
A temperature rise of the frozen food packs,
during defrosting, may shorten their safe storage
life.
Interior light
The light bulb inside the refrigerator compartment
can be reached as follows:
- unscrew the light cover securing screw.
- unhook the moving part as shown in the figure.
If the light does not come on when the door is open,
check that it is screwed into place properly. If it still
does not light up, change the bulb. The rating is
shown on the light bulb cover.
Periodic cleaning
Many proprietary kitchen surface cleaners
contain chemicals that can attack/damage the
plastics used in this appliance. For this reason it
is recommended that the outer casing of this
appliance is only cleaned with warm water with a
little washing-up liquid added. Clean the inside
with warm water and bicarbonate of soda.
Rinse and dry thoroughly.
Clean the condenser (black grill) and the
compressor at the back of the appliance with a
brush or a vacuum cleaner.This operation will
improve the performance of the appliance and save
electricity consumption.
D411
49
H
G
E
F
D
F
F
F
Het wijzigen van de
deurdraairichting
Neem vóór het wijzigen van de deurdraairichting
de stekker uit het stopcontact.
Ga nu verder als volgt te werk:
1. Ventilatierooster (D) verwijderen.
2. Onderscharnier (E) losschroeven en verwijderen.
3. Trek de deur van het tussenscharnier (H) en leg
hem terzijde.
4. Verwijder het tussenscharnier, trek de deur van
stift (G)
5. Bovenste scharnierpen (G) van het
bovenscharnier verwijderen en aan de
tegenovergestelde kant weer monteren, na de
dopjes verwijderd te hebben. Monteer de dopjes
nu aan de andere kant.
6. Plaats de bovendeur, het
tussenscharnier en
de onderdeur
7. Onderscharnier (E) aan de tegenovergestelde
kant monteren met behulp van de eerder
verwijderde schroeven.
8. Afdekdopje (F) van het ventilatierooster (D)
nemen en aan de tegenovergestelde kant weer
monteren.
9. Ventilatierooster weer terugplaatsen (D).
10.De Handgreep losschroeven AAn de andere kant
van de deur bevestigen nadat u de dopjes met
een priem doorgeprikt heeft. De vrijgekomen
gaatjes afsluiten met den bijgeleverde dopjes;
deze vindt u in het zakje van de documentatie.
Het tussenscharnier verstelt u horizontaal met een
stuk gereedschap na de twee schroeven losgedraaid
te hebben.
Belangrijk:
Controleer na de richting van de deuren
gewijzigd te hebben, of alle schroeven goed
vastgedraaid zitten en of het deurrubber goed op
de sponning sluit. In een koud vertrek (in de
winter) kan het gebeuren dat dat niet het geval
is. Na enkele dagen zal het rubber zich echter
aangepast hebben. Wilt u dat bespoedigen, dan
kunt u het rubber warm maken met een föhn.
Muur-afstandshouders
In het documentenzakje bevinden zich twee
afstandhouders die in de bovenste hoeken aan
de achterzijde geplaatst dienen te worden.
Steek de afstandhouders in de gaten en let erop dat
de pijl (A) staat zoals in de figuur; draai de
afstandhouders dan 45° (pijl staat verticaal) zodat ze
vast komen te zitten in Fig..
PR60
A
45°
… 16 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Electrolux erb 2436 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Electrolux erb 2436 in the language / languages: English, German, Dutch, Danish, Swedish, Finnish as an attachment in your email.

The manual is 1,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info