129367
8
Zoom out
Zoom in
Previous page
1/32
Next page
EN
8
8
INSTALLATION
Drilling the Support surface and Fitting the Hood
• The Hood can be fitted directly on the
lower surface of the Wall Units (650 mm
min. above the Cooker Top) using the snap-
on Side Supports.
Make an opening on the lower surface of
the Wall Unit, as indicated. (fig.1)
Before carrying out the installation, the
wooden transportation protections screwed
on the visor and on the canopy body must
be removed. (fig.2)
Choose the correct flange measure basing
on the air outlet diameter and insert it to the
upper air outlet opening. (fig.3)
Screw the closing profile 20 onto the rear
part of the hood, using the screws 12f (2.9
x 9.5) provided. (fig.4)
Open the sliding suction panel.
• Remove the metal grease filters one by one
after having disconnected the relative fas-
tening elements.
Close the sliding suction panel again.
Insert the Hood until the snap-on side sup-
ports click into place. (fig.5)
Open the sliding suction panel.
Lock in position by tightening the screws
Vf from underneath the Hood. (fig.5)
If necessary, adjust the whole filter holder
unit and proceed as follows:
Loosen the four adjustment screws Vr
and close the sliding panel again. (fig.6)
Move the entire filter holder unit until it
is properly aligned with the wall unit.
(fig.7)
Keeping the hood canopy still, remove
the sliding panel and lock the adjustment
screws again. (fig.6)
The hood can now be fastened to the
wall unit using the four screws 12a (3.5
x 16) provided. (fig.8)
Replace the metal grease filters.
Close the sliding suction panel again.
523
162
1
2
9
10a
10a
10b
3
5
Vr
6
7
12a
8
4
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Electrolux efp60241x at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Electrolux efp60241x in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info