510295
23
Zoom out
Zoom in
Previous page
1/60
Next page
touchpads until the child lock indi-
cator goes off.
6.2 Water hardness and
conductivity
Water hardness is different for different lo-
cations. Water hardness has an effect on
the water conductivity and on the con-
ductivity sensor of the appliance. If you
know, the value of the water conductivity
you can adjust the sensor in order to have
better drying results.
Adjusting the conductivity sensor
1.
Use the programme knob to set any
programme.
2. Press and hold touchpads (A) and (B)
at the same time until one of the these
indicators comes on:
(low <300 μS/cm)
(moderate 300-600 μS/cm)
(high >600 μS/cm)
3.
Press the touchpad (E) again and
again until the indicator of the correct
level comes on.
4. To confirm the adjustment, press and
hold touchpads (A) and (B) at the
same time for approximately 2 sec-
onds.
7. DAILY USE
Before you use the appliance for the
first time
1.
Clean the appliance drum with a moist
cloth.
2.
Start a short programme (e.g. 30 mi-
nutes) with moist laundry.
7.1 Starting a programme
without delay start
1.
Prepare the laundry and load the ap-
pliance.
2. Set the correct programme and op-
tions for the type of load.
The display shows the programme
duration.
3.
Press the Start/Pauze (Start/Pause)
touchpad, the programme starts.
CAUTION!
Make sure that when you close
the door, the laundry does not
catch between the appliance door
and the rubber seal.
7.2 Starting the programme with
delay start
1.
Set the correct programme and op-
tions for the type of load.
2.
Press the delay start button again and
again until the display shows the delay
time you want to set.
You can delay the start of a pro-
gramme from a minimum of 30 mi-
nutes to a maximum of 20 hours.
3.
Press the Start/Pauze (Start/Pause)
touchpad, the countdown starts. The
display shows the countdown of the
delay start.
When the countdown is completed,
the programme starts.
7.3 Change a programme
1.
Turn the Programme knob to
OFF
2. Set the programme.
7.4 At the end of the
programme
When the programme is completed,
An intermittent acoustic signal oper-
ates.
The indicator
flashes.
The indicator
comes on.
The Start/Pauze (Start/Pause) indicator
is on.
The appliance continues to operate with
the crease guard phase for approximately
other 30 minutes.
The crease guard phase removes creases
from your laundry.
You can remove the laundry before the
crease guard phase is completed. We
ENGLISH 23
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Electrolux EDP2074PEW at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Electrolux EDP2074PEW in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 23,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info