632961

Electric Mobility Rascal 600F Manual

33
Zoom out
Zoom in
Previous page
1/42
Next page
Rascal R600 Scooter Owner’s Manual
EMC Part: 19271200 • Rev. 03 • 06/01/2003
28
Re-Assembly Notes: Slide the wheel onto axle, align key with slot in
axle. If snug, tap on wheel lightly with a rubber mallet. Replace the
hardware and tighten securely.
Front Wheel Removal Using the proper size wrenches on the nut and bolt, remove nut. Hold
wheel and slide the bolt out of fork, being careful not to lose any of the
wheel spacers.
Re-Assembly Notes: Align the wheel in the front fork and slide the bolt
through the fork and the wheel. Replace wheel spacers as required.
Tighten the nut and bolt securely with the proper size wrenches. Check
that the wheel spins freely. If not, loosen the nut (in quarter turn
increments) until the wheel spins freely.
Tire Tread Wear Measure tire tread depth. If less than 1/32", it is recommended you
replace the tire.
Seat Post Lubrication The seat should rotate freely. Clean and lubricate the top of the seat
post and the inside of the seat base attached to the seat. Lubricate with
petroleum jelly or other similar lubricant.
Caster Wheels If the caster wheels are badly worn; it is recommended that they be
replaced.
Clock Battery After time, the clock may begin to lose time, or stop, when the battery
runs down. The battery is easily replaced by removing the clock from the
dash, prying open the clock’s case, and inserting a new battery. Use the
following to replace the clock battery.
Battery Types: SR626SW, UCC 377, Ray-O-Vac RW329
1. Remove clock from the dash.
2. Use a small screwdriver to open the case by inserting the
screwdriver blade into the notch on the back cover. Gently twist
blade so that the back cover comes off.
3. Slide the metal battery cover plate aside and remove battery.
4. Install new battery with positive pole (+) facing outwards. Slide
battery cover back in place over new battery.
After replacing battery, make sure time setting is correct before
replacing clock into dash.
Electrical Connections Check battery terminals and all plug connectors to make sure that a
tight connection is made. If battery terminals are corroded, disconnect
the leads and clean all connections with a soft wire brush. Re-connect
leads and apply a protective coating (e.g., petroleum jelly, etc.) to
prevent corrosion.
… 33 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Electric Mobility Rascal 600F at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Electric Mobility Rascal 600F in the language / languages: English as an attachment in your email.

The manual is 6,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info