632961

Electric Mobility Rascal 600F Manual

31
Zoom out
Zoom in
Previous page
1/42
Next page
Rascal R600 Scooter Owner’s Manual
EMC Part: 19271200 • Rev. 03 • 06/01/2003
26
1. Remove Seat, Batteries, Dash or Tiller, and Front Section as described previously.
2. With the unit still standing upright on the rear bumper, disconnect both electrical connectors (4
prong and 2 prong) of the Drivetrain Power Harness. Remove both of the Quick Disconnect Pins
used to hold leaf springs into position.
3. Grasp the top center of the frame and the seatpost. Rotate unit out and lift straight up.
Transporting your Scooter
By Car — To transport your disassembled scooter by car, place each of the components into the trunk,
being careful not to scratch or mark any of the finished surfaces. Make sure the batteries are right side
up and on a level spot in your trunk. If you need assistance lifting weights, consider asking Electric
Mobility’s Customer Service Department or your authorized service center about the Power Trunk Lift.
This device will assist you in transporting your scooter by transferring these components in and out of
your trunk with very little effort. (See “Specifications” for more information on weights).
By Airplane — To transport your unit on an airplane, we recommend that you call your airline at least
24 hours in advance to ensure that they are aware of your scooter. Your Rascal batteries are approved
for airline travel. Ask specifically where and with whom you should drop the unit off and where and with
whom you should retrieve it at your destination.
Remember to bring this manual with you as a reference on your trip. Your manual will assist you in
disassembling and re-assembling your unit if required.
Prior to leaving the airport, remember to test the unit out when first getting on it. Direct any questions
to the airline personnel if the unit does not work as it did prior to transportation.
If traveling outside of the United States, you may require a different charger or an adapter for your
present charger. Customer Service or your authorized service center can help you answer these
questions and supply you with the charger or adapter you require.
By Bus, Van or Truck without Disassembly — If transporting your scooter fully assembled in a van,
bus, or truck, secure it to the floor using a four point tie-down system. Make sure that the battery
tiedown straps are secure prior to transportation.
The operator of the scooter should then be seated in an approved seat in the transporting vehicle.
WARNING!
This scooter does not meet Federal Safety Standards for motor vehicle
seating. Do not sit, nor permit anyone else to sit, in the seat of your
scooter during transportation in a motor vehicle as this poses a
significant risk of bodily injury or even death.
… 31 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Electric Mobility Rascal 600F at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Electric Mobility Rascal 600F in the language / languages: English as an attachment in your email.

The manual is 6,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info