775454
7
Zoom out
Zoom in
Previous page
1/13
Next page
1. There are two possible hardware sets. Check to see which one you have:
A. 2 short M5 bolts (8mm) and 1 long M5 bolt (12mm)
B. 2 short M5 bolts (8mm), 1 very long M6 bolt (45mm), and 1 M6 nut
2. Apply Loctite (or similar threadlocker) to the lower half of the threads
on the long bolt as shown.
3. With the fork facing forward, guide the fender through the rear of the fork.
If you have hardware set (A), insert the long M5 bolt through the fender
bracket and into the threaded hole in the rear of the fork.
If you have hardware set (B), insert the very long M6 bolt through the front
of the fork and fender bracket, and thread the M6 nut onto the bolt. Do
not fully tighten the bolts at this time.
4. Use the two shorter bolts to attach the fender struts to the mounting
points at the base of the fork.
5. Once all three bolts are in place, securely tighten all three bolts.
 If the fender must be removed, always clean and apply
threadlocker to the lower half of the threads during reinstallation.
Install the front fender


Long bolt
Short bolts
Rim brake preparation:
1. Rotate the lever upward to open the brake
(caliper brake).
2. Manually pull the brake cable from the saddle
to open the brake (V-brake).
Disc brake preparation:
1. Remove the front disc brake pad spacer.
Front wheel installation preparation (Adult bike)
A
1 2
B
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Electra Bike at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Electra Bike in the language / languages: English as an attachment in your email.

The manual is 4.96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info