561006
32
Zoom out
Zoom in
Previous page
1/48
Next page
Description and use of the control panel
Page 28
3 MODE
There are two possible options with the “MODE” parameter.
AUTO This is the normal setting. The ELAC subwoofer is kept in power-saving stand-by mode (blue stand-
by LED is on). The inputs are constantly monitored by a sensor. As soon as a sufficiently strong bass sig-
nal is present, the amplifier is switched on. Within tenths of a second, the subwoofer is ready for operation,
and the stand-by LED goes out.
If the input signals stop, the ELAC subwoofer stays for another approx. 15 minutes in fully-active status,
and then returns to stand-by mode.
Tip: If the automatic switch on system does not react until at higher volumes, then increase the bass/LFE
level of your surround receiver and reduce the level on the subwoofer itself by the same degree. Acousti-
cally, this has no effect. The subwoofer will however switch on even at low volumes.
ON The subwoofer is permanently completely switched on, and does not switch to stand-by mode.
To completely switch off the subwoofer (isolation from power supply) the mains switch must be used. This is lo-
cated on the rear panel of the subwoofer.
To adjust the operating modes, go to the rotation menu with one of the outer arrow keys to select “Mode”. By
pressing the selector key in the middle, you arrive at operating mode selection. Now select the required operating
mode with one of the outer arrow keys, and return to the rotation menu by pressing the selector key. Your selected
mode will now be shown.
4 DISPLAY
There are two modes for the display:
AUTO This is the normal setting. If no input signals arrive via the buttons or remote control, then the ELAC
subwoofer waits for another 1 minute and then automatically switches off the background lighting of the
display. When a button is pressed, the background lighting is automatically switched on again.
ON The background lighting of the subwoofer display is permanently switched on.
To adjust the display mode, go to the rotation menu with one of the outer arrow keys to select “Display”. By press-
ing the selector key in the middle, you arrive at operating mode selection. Now select the required operating mode
with one of the outer arrow keys, and return to the rotation menu by pressing the selector key. Your selected mode
will now be shown.
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elac SUB 211D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elac SUB 211D in the language / languages: English, German as an attachment in your email.

The manual is 3,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info