561005
35
Zoom out
Zoom in
Previous page
1/44
Next page
Connection and starting 32
If you want to direct these tones in case of phone calls again to the internal speakers (for
privacy), you have to shut off the Bluetooth® connection. This is possible either through a
suitable key sequence on your mobile phone or by switching the POWER mode selector (pt.
6) to “BT OFF”. In that case the mobile phone asks for a confirmation of the break. When
that is done the reproduction of signal tones and speech as well as music is again via your
mobile phone.
With the first re-start after initial installation of a new Bluetooth® connection your music
source tries automatically to restore this Bluetooth® connection.
Receiving Bluetooth® signals needs a small antenna that projects out of the rear panel of
the ELAC complete active subwoofer as a short “stub”.
Important:
For optimum transmission quality of music signals the files should be compressed with a
data rate of 192 kb/sec.
12 POLARITY
Under some circumstances it is clever to invert the polarity of both satellite speakers in rela-
tion to the subwoofer (turning the phase by 180°). This can be necessary under special room
conditions and/or relative positions of subwoofer and satellites. If you feel the bass is too
weak (especially the higher or “Kick” bass), or it seems muddy and not controlled, you
should once try polarity inversion if it helps.
The phase will be turned by 180°
by connecting BOTH satellite
speakers knowingly with wrong
polarity. The positive cable pole
(“+”) is connected to the negative
output clamp (“-“) and vice versa.
For clarity the sketch shows the
“+”-pole in brighter colour. This
must be done with BOTH
channels.
Compare this to the standard
connection. The version that
sounds more full is the proper one,
possibly allowing a slight reduction
of subwoofer level (or crossover
frequency) and thereby improving
the quality.
35


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elac SUB 2010 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elac SUB 2010 in the language / languages: English, German as an attachment in your email.

The manual is 3,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info