561005

Elac SUB 2010 Manual

29
Zoom out
Zoom in
Previous page
1/44
Next page
Connection and starting 26
Important:
Should you intent to use the ELAC complete active subwoofer as a subwoofer alone,
-- without satellite speakers --, you can skip this chapter and continue at page 27, pt.3.
1 SAT OUT L
2 SAT OUT R
Note:
Especially suited as satellite speakers are ELAC 301 and ELAC Starlet.
These are available together with ELAC MicroSUB 2010 BT in 2 combination sets:
ELAC MicroMAGIC 2.1 (with 2 x ELAC 301) and ELAC MicroSTAR 2.1 (with 2 x ELAC Star-
let).
These combinations are perfectly tuned 2.1 speaker systems that guarantee great music
pleasure at minimum space.
But the ELAC complete active subwoofer is also suited for every other satellite speaker.
The internal filtering of lowest frequencies (<80 Hz) saves the satellite speakers from unnec-
essary load in favour of a more efficient and effortless reproduction of mid and high parts of
the spectrum.
The spring-type terminals SAT
OUT L/R allow the connection of 2
satellite speakers (Left, Right) to
the ELAC complete active
subwoofer. Here you can use the
included speaker cables, which go
to the satellites. For clarity the
figure at left shows the “+”-pole in
brighter colour. Of course you can
use other cables than the included
ones.
During cable insertion into the
cross-hole please take some care
in order to avoid short circuit
against the neighbouring clamp or
the housing. Typical HQ speaker
cables today have 2.5 mm² cross-
sections. 1.5 mm² types are sufficient without serious losses up to about 6 meters (20 feet)
with 4-Ohm speakers, and up to 12 meters (40 feet) with 8-Ohm speakers. For much shorter
distances (on the desktop) you can cut the cable and also use less cross-section cable
types.
The satellite speakers used should have “Nominal Impedance” not below 4 Ohms (3 Ohms
minimum). The impedance specification you should find printed on the rear side of the
speaker or the owners manual.
!!! Caution !!!
These Connections are “Outputs”, not “Inputs”.
They are suited solely for connection of passive loudspeakers. Connection to an amplifier
output could result in – worst case - damage to the active subwoofer and/or the amplifier!!!
… 29 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elac SUB 2010 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elac SUB 2010 in the language / languages: English, German as an attachment in your email.

The manual is 3,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info