810951
76
Zoom out
Zoom in
Previous page
1/79
Next page
76
19.1. Calibration depending on vacuum pressure (F05)
The product features a “pressure tap” on the hopper
To calibrate proceed as follows:
Load the screw as described in the installer settings chapter
After loading the screw, empty the crucible
Switch on the product; when on minimum power, wait at least 5 minutes
Calibrate the manometer at point zero according to the relative instructions
Open the pressure tap plug
Connect the pressure gauge to the pellet hopper pressure tap
Check that the vacuum pressure value is within the range indicated in the table below; if not, see the following
picture
PRODUCT
VACUUM PRESSURE VALUE
Spy110+
(48-52) Pa
Metro110+
(48-52) Pa
Yung130++
(48-52) Pa
Daily130++
(48-52) Pa
When the operation has been completed, disconnect the pressure gauge and close the pressure tap plug
Does not replace calibration carried out by the service centre
The combustion air intake must NOT be connected to pipes during calibration
A pressure gauge is required for calibration
76


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for EK63-EdilKamin Yung 130 plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of EK63-EdilKamin Yung 130 plus in the language / languages: English as an attachment in your email.

The manual is 8.84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of EK63-EdilKamin Yung 130 plus

EK63-EdilKamin Yung 130 plus Usermanual and installation guide - German - 80 pages

EK63-EdilKamin Yung 130 plus Usermanual and installation guide - Dutch - 80 pages

EK63-EdilKamin Yung 130 plus Usermanual and installation guide - French - 81 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info