810943
10
Zoom out
Zoom in
Previous page
1/32
Next page
10
WATER CIRCUIT INSTALLATION
(FOR TECHNICAL ASSISTANCE CENTRE USE
ONLY)
SPOT100 H MUST NEVER OPERATE WITHOUT
WATER IN THE SYSTEM.
OPERATING PRESSURE MUST BE ABOUT 1.5
BARS.
SWITCHING ON WHEN “DRY CAN DAMAGE
THE STOVE.
Plumbing must be carried out by quali ed personnel
and a declaration of conformity must be issued
pursuant to Min. Decree 37
ex Law 46/90.
In any case, it is essential that the laws in force in the
country concerned are followed.
• For the water input, return and discharge
connections, opt for suitable solutions to facilitate, if
necessary, a any future re-positioning
of the stove.
• For better performance, the primary circuit (where
the heat generator is situated) must be separate from
the secondary circuit
(user).
For example, using a plate exchanger which allows
the exchange of energy in the form of heat without
mixing the waters.
WATER TREATMENT
It may be necessary to add anti-freeze, anti-scaling
and anti-corrosion additives suitable for light alloys.
If the water for lling and topping up the stove has a
hardness of above 35°F, use a water softener.
For suggestions, consult the standard UNI 8065-1989
(Water treatment in heating systems for civil use).
Check that the plumbing system is correctly
executed and is equipped with an expansion
tank su cient to guarantee its safety. The
presence of the built-in tank in the thermo stove
DOES NOT guarantee adequate protection from
thermal expansion su ered by the water of the
entire system. Therefore, the installer will have
to evaluate the possible need for an additional
expansion tank, depending on the type of system
served.
The direct connection to the radiators, due to the
small diameter of their pipes, prevents regular
operation.
The water return temperature to the product
must be higher than at least 50-55 ° C to avoid
condensation. Depending on the system, the
installer must evaluate whether valves or anti-
condensation pumps are needed.
Fill the system through the lling tap (it is recommended
not to exceed a pressure of 1.5 bar).
During the lling phase, let the pump “vent”;
opening the manual vents
This operation must also be carried out periodically
thereafter.
Gauge
The thermo stove has an analogue reading of the
water pressure.
So there is an analogue pressure gauge on the back
of the product.
NOTE:
• The installer must assess whether an extra expansion tank is necessary, according to the type of system served.
• During the production of domestic hot water, there is a temporary reduction in supply to the radiators.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for EK63-EdilKamin Spot 100H at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of EK63-EdilKamin Spot 100H in the language / languages: English as an attachment in your email.

The manual is 2.19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of EK63-EdilKamin Spot 100H

EK63-EdilKamin Spot 100H Usermanual and installation guide - German - 32 pages

EK63-EdilKamin Spot 100H Usermanual and installation guide - French - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info