13
GB
ƽ Important.
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety information with due care. Keep this manual in
a safe place so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and the safety
information as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety information.
1. Safety information
Please refer to the booklet included in delivery for the
safety information.
ƽ CAUTION
Read all the safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1)
1. Drill chuck
2. Drill depth stop
3. Drill/hammer drill selector switch
4. Locking button
5. ON/OFF switch
6. Speed controller
7. Clockwise/Counter-clockwise switch
8. Additional handle
9. Spindle lock
10. Storage compartment for drill bits
11. LED light
3. Items supplied
Take all parts out of the packaging and check that
they are complete.
Hammer drill RT-ID 65
Additional handle
Depth stop
Operating instructions
Safety Information
4. Intended use
The drill is designed for drilling holes into wood, iron,
non-ferrous metals and rock using the appropriate
bits.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user/operator and not the manufacturer
will be liable for any damage or injuries of any kind
caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
equipment is used in commercial, trade or industrial
businesses or for equivalent purposes.
5. Technical data
Mains voltage: 230-240 V ~ 50 Hz
Power input: 650 W
Idling speed: 0-3,000 min
-1
Drilling capacity: Concrete 13 mm
Steel 10 mm
Wood 25 mm
Protection class: II / Ɓ
Weight: 2.2 kg
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745-1 and EN 60745-2-1.
L
pA
sound pressure level 93.3 dB(A)
K
pA
uncertainty 3 dB
L
WA
sound power level 104.3 dB(A)
K
WA
uncertainty 3 dB
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Hammer drilling in concrete (handle)
Vibration emission value a
h,ID
= 16.306 m/s
2
K uncertainty = 1.5 m/s
2
