640361
28
Zoom out
Zoom in
Previous page
1/41
Next page
25
9.5. Fitting the limit switches
Use the emergency interlock bypass to disengage the motor.
Close the garage door by hand.
Establish the position of the front limit switch ‘Close’. The
limit switches are actuated by the slide.
Screw the ‘Close’ limit switch (with the long cable) on the
aluminium switch mount (see Figure B), hook in rail ‘B’
and fix with a self-tapping screw size 2.9 x 6.5 mm.
Open the garage door by hand.
Establish the position of the rear limit switch ‘Open’.
Screw the ‘Open’ limit switch (with the short cable) on
the aluminium switch mount (see Figure A), hook in rail
‘D’ and fix with a self-tapping screw.
Lay the cables in rails D + B and insert the terminal
clamps in the side channel of the rails.
Move the garage door by hand until the slide (36)
interlocks with the driver ring (40).
Important! Please note:
Never allow the motor to run when it is disengaged!
Precision adjustment of the limit switching is possible
after the motor is put into operation!
9.5 Монтаж концевых выключателей
Разблокировать привод при помощи аварийной
разблокировки.
Закрыть вручную ворота гаража.
Установить позицию переднего концевого выключателя “
Закрыто “. Концевые выключатели двигаются на салазках.
Концевой выключатель “ Закрыто “ /с длинным кабелем/
прикрепить шурупом к алюминеевому корпусу
выключателя / см. рис. В/, в направляющую “ В “ вложить и
закрепить шурупом 2,9 х 6,5 мм.
Открыть вручную ворота гаража.
Установить позицию заднего концевого выключателя “
Открыто“.
Концевой выключатель “ Открыто“ /с коротким кабелем /
прикрепить шурупом к алюминеевому корпусу /см. рис. А/,
в направляющую “D“ вложить и закрепить шурупом.
Положить кабель в шины D + В и вставить крепления
клемм в боковые бороздки.
Ворота гаража открыть вручную до положения, пока
салазка /36/ не упрется в поводок /40/.
Важное указание:
Никогда не позволяйте работать приводу в
разблокированном состоянии!
Доводка концевых выключателей должна произойти
после ввода устройства в эксплуатацию.
RUS
Anleitung GT 52 02.11.2001 8:51 Uhr Seite 25
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Einhell GT52 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Einhell GT52 in the language / languages: English, Swedish, Finnish as an attachment in your email.

The manual is 2,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info