605745
20
Zoom out
Zoom in
Previous page
1/52
Next page
GB
- 20 -
Handling
1. Do not let the combustion engine run in enc-
losed areas, as dangerous carbon monoxide
gas can build up.
2. Only mow in broad daylight or in well-lit con-
ditions. If possible, avoid using the equipment
on wet grass.
3. Disengage the auxiliary drive unit and set the
drive lever to the neutral position before you
start the mower.
4. Do not use the equipment on slopes with a
gradient of over 10°.
5. Remember that there is no such thing as a
“safe slope”. Driving on grassy slopes requi-
res particular concentration. To protect your-
self against overturning you should:
- Not stop or start o suddenly when you are
driving up or down a slope.
- Engage slowly, leave the engine engaged,
especially when driving downslope.
- Keep to a low speed on slopes and on tight
turns.
- Watch out carefully for mounds, hollows and
other unseen dangers.
- Never mow across the slope unless the
machine construction is designed for the
purpose.
6. Be careful when you tow any loads or if you
use any heavy equipment. Only use approved
tow hitches.
7. Only attach loads that you know you can con-
trol.
8. Do not attempt to drive tight turns. Exercise
caution when reversing.
9. Pay special attention to car tra c if you cross
a street or if you are mowing close by one.
10. Stop the knife before crossing over any areas
other than grass.
11. If you use any attachments, make sure that
this does not cause grass to be thrown in the
direction of people and that no persons are
nearby.
12. Never use machines if protective equipment
is damaged or not tted.
13. Do not adjust or overclock the motor speed
settings. Operating the equipment at excessi-
ve speed may increase the risk of accidents.
14. Before you leave the driver’s seat:
- Disengage the drive unit for the attachment
and lower it.
- Engage idle mode and apply the locking
brake.
- Switch o the engine and pull out the igniti-
on key.
15. Disengage the drive unit for the attachments,
switch o the engine and pull out the spark
boot plug and the ignition key:
- Before you dislodge any blockages or clogs
in the chute.
- Before carrying out any checks, cleaning or
other work on the machine.
- If you have struck a foreign object. Examine
the machine for signs of damage and carry
out any necessary repairs before restarting
and continuing to work with the machine.
- If the machine begins to experience excepti-
onally strong vibrations, immediately check it.
16. Disengage the drive units for attachments
whenever you intend to transport the mower
or not use it for any length of time.
17. Switch o the engine and disengage the drive
unit for the attachments:
- Before you refuel.
- Before you remove any grass catching de-
vices.
- Before you change the height setting if this
cannot be done from the user’s position.
18. Close the engine‘s throttle valve when the
machine has run down. When you have -
nished mowing with the machine, close the
petrol stopcock if it has one.
19. It is prohibited to work when there is a risk of
bad weather or lightning.
20. Never use the lawnmower if you are tired, ill
or under the in uence of drugs, alcohol or
medication.
21. Be particularly carefully when mowing on the
banks of streams, ponds or similar.
22. The lawnmower is not allowed to be used
when the debris bag is not tted.
Maintenance and storage
1. Make sure that all nuts, bolts and screws are
tightened securely and that the machine is in
safe working condition.
2. Never store the mower (with petrol in the
tank) inside a building in which petrol fumes
could come into contact with open ames or
sparks.
3. Allow the engine to cool before you put the
lawn mower in an enclosed area.
4. In order to avoid re hazards, keep the engi-
ne, exhaust and the area around the fuel tank
free from grass, leaves and leaking grease
(oil).
5. Routinely check the grass basket for signs of
wear and impaired functionality.
6. For your own safety, replace worn or dama-
ged parts without delay.
Anl_GE_TM_102_BS_SPK7.indb 20Anl_GE_TM_102_BS_SPK7.indb 20 21.01.15 08:4821.01.15 08:48
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Einhell GE-TM 102 BS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Einhell GE-TM 102 BS in the language / languages: English, German, French as an attachment in your email.

The manual is 0,88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info