605696
27
Zoom out
Zoom in
Previous page
1/138
Next page
GB
- 27 -
Information on correct mowing
It is recommended that you overlap the mowing
swaths.
Only use a sharp blade that is in good condition.
This will prevent the grass blades from fraying
and the lawn from turning yellow.
Try to mow in straight lines for a nice, clean look.
The swaths should overlap each other by a few
centimeters in order to avoid stripes.
How frequently you should mow your lawn de-
pends mainly on the speed at which the grass
grows. In the main growing season (May - June)
you will probably need to mow the lawn twice
a week, otherwise just once a week. The cut-
ting height should be between 4 - 6cm and the
amount of growth before mowing again should be
4 - 5cm. If the grass is allowed to grow somewhat
longer for whatever reason, do not make the mis-
take of cutting it back to the normal height in one
go. This will harm the lawn. Never cut it back by
more than half the height in one go.
Keep the underside of the mower housing clean
and remove grass build-up. Deposits not only
make it more di cult to start the mower; they
decrease the quality of the cut and make it harder
for the equipment to bag the grass.
Always mow along inclines (not up and down).
You can prevent the lawn mower from slipping
down by holding a position at an angle upwards.
Select the cutting height according to the length
of the grass. Make several passes so that no
more than 4 cm of grass are cut at one time.
Switch o the motor before doing any checks on
the blade. Keep in mind that the blade continues
to rotate for a few seconds after the motor has
been switched o .
Never attempt to stop the blade. Regularly check
to see if the blade is securely attached, is in good
condition and is sharp. If the contrary is the case,
sharpen the blade or replace it. In the event that
the blade strikes an object, immediately switch
o the lawn mower and wait for the blade to come
to a complete stop. Then inspect the condition of
the blade and the blade mount. Replace any parts
that are damaged.
Lay the power cable on the ground in loops in
front of the power outlet. Mow away from the po-
wer outlet and cable, making sure that the power
cable always trails in the mowed grass so that the
lawn mower does not travel over the cable.
As soon as grass clippings start to trail the lawn
mower, it is time to empty the grass basket.
Important! Before taking o the grass basket,
switch o the motor and wait until the blade has
come to a stop.
To take o the grass basket, use one hand to lift
up the chute ap and the other to grab onto the
basket handle. Remove the basket. For safety
reasons, the chute ap automatically drops after
removing the grass basket, closing o the rear
chute opening. If any grass remains in the ope-
ning, it will be easier to restart the motor if you pull
the mower back approximately 1m.
Do not use your hands or feet to remove clippings
in or on the mower housing, but instead use suita-
ble tools such as a brush or a broom.
In order to ensure that the majority of grass clip-
pings are picked up, the inside of both the grass
basket and especially the net must be cleaned
after each use.
Reattach the grass basket only when the motor is
switched o and the blade has stopped.
Lift up the chute ap with one hand and, holding
the grass basket by its handle with the other
hand, hang in the basket from the top.
7. Replacing the power cable
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
Anl_GE_EM_1233_M_SPK1.indb 27Anl_GE_EM_1233_M_SPK1.indb 27 09.09.13 18:0909.09.13 18:09
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Einhell GE-EM 1233 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Einhell GE-EM 1233 in the language / languages: English, Danish, Swedish, Norwegian as an attachment in your email.

The manual is 2,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Einhell GE-EM 1233

Einhell GE-EM 1233 User Manual - German - 90 pages

Einhell GE-EM 1233 Additional guide - German - 2 pages

Einhell GE-EM 1233 User Manual - Dutch - 90 pages

Einhell GE-EM 1233 Additional guide - Dutch - 2 pages

Einhell GE-EM 1233 User Manual - French - 90 pages

Einhell GE-EM 1233 Additional guide - French - 2 pages

Einhell GE-EM 1233 User Manual - Italian - 90 pages

Einhell GE-EM 1233 Additional guide - Italian - 2 pages

Einhell GE-EM 1233 User Manual - Portuguese - 90 pages

Einhell GE-EM 1233 Additional guide - Portuguese - 2 pages

Einhell GE-EM 1233 User Manual - Spanish - 90 pages

Einhell GE-EM 1233 Additional guide - Spanish - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info