5. Technical data
Mains voltage: 230 V ~ 50 Hz
Power input: 600 W
Idling speed: 1,600 min
-1
Cutting length 520 mm
Cutter rail length 560 mm
Tooth spacing 25 mm
Max. cutting thickness 21 mm
Cuts/min 3200
Protection class: II / 쓑
Weight: 4.2 kg
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L
pA
sound pressure level 76.2 dB(A)
K
pA
uncertainty 3 dB(A)
L
WA
sound power level 96.2 dB(A)
K
WA
uncertainty 3 dB(A)
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Vibration emission values (vector sum of three
directions) determined in accordance with EN 60745.
Vibration emission value a
h
= 3.513 m/s²
Uncertainty K = 1.5 m/s²
Warning!
The specified vibration emission value was
established in accordance with a standardized testing
method. It may change according to how the electric
equipment is used and may exceed the specified
value in exceptional circumstances.
The specified vibration emission value can be used to
compare the equipment with another electric power
tools.
The specified vibration emission value can be used
for initial assessment of a harmful effect.
Reduce noise generation and vibration to a
minimum!
n Use only equipment that is in perfect condition.
n Maintain and clean the equipment regularly.
n Adopt your way of working to the equipment.
n Do not overload the equipment.
n Have the equipment checked if necessary.
n Switch off the equipment when not in use.
n Wear gloves.
Residual risks
Even if you use this electric power tool in
accordance to instructions, certain residual risks
cannot be eliminated. The following hazards may
arise in connection with the equipment’s
construction and layout:
1. Damage to hearing if no suitable ear protection is
applied.
2. Health damage caused by hand-arm vibrations if
the equipment is used over a longer period or is
not properly guided and maintained.
6. Before starting the equipment
n Before you connect the equipment to the power
supply make sure that the data on the rating plate
are identical to the supply voltage.
n Always pull out the power plug before making
adjustments to the equipment.
Rear swiveling handle
The hedge trimmer is fitted with a rear swiveling
handle. This can be turned counter-clockwise through
90° and clockwise through both 90° and 180°. To do
so, you must first retract the lock (Figure 2/Item A)
and hold. Then turn the handle and release the lock. If
you turn it counter-clockwise the handle will lock at an
angle of 90°. If you turn it clockwise the handle will
lock at an angle of 90° and 180°.
To return the handle to its original position, pull the
lock (A) back again and hold. When the handle is
back in its standard position, release the lock again.
Important. Make sure that the handle engages.
The handle should be turned through 90° for vertical
cuts and through 180° for overhead cuts.
13
GB