Manual Einhell GE-CT 18 Li Kit (page 23 of 82) (English, German, Dutch, French, Italian, Swedish, Finnish)

605918

Zoom out

Zoom in

1/82

- 23 -

5.4 Adjusting the additional handle (Fig. 8)

Undo the adjustment lock (Fig. 8/Item 3) for the

additional handle until it can be moved forwards

and backwards without any great resistance. Set

the required position and tighten the securing

screw again.

5.5 Adjusting the angle of tilt of the guide

handle (Fig. 9)

Press the button for the angle of tilt adjustment

(Fig. 9/Item K). Now you can set the long handle

to the required tilt. Release the button and allow

the handle to lock into position to ﬁ x the angle of

tilt. Three diﬀ erent locking angles are possible.

5.6. Installing the battery (Fig. 10/11)

Press the side pushlock buttons of the battery

pack as shown in Fig. 10 and push the battery

pack into the mount provided. When the battery

pack is positioned as in Fig. 11, make sure that

the pushlock buttons latch in place! To remove the

battery pack, proceed in reverse order.

5.7 Charging the battery (Fig. 12a)

1. Take the battery pack out of the equipment.

Do this by pressing the side pushlock buttons.

2. Check that your mains voltage is the same as

that marked on the rating plate of the battery

charger. Insert the power plug of the charger

(10) into the mains socket outlet. The green

LED will then begin to ﬂ ash.

3. Insert the battery pack (11) into the battery

charger (10).

4. In section „Charger indicator“ you will ﬁ nd a

table with an explanation of the LED indicator

on the charger.

The battery pack can become a little warm during

the charging. This is normal. If the battery pack

fails to charge, check:

•

whether there is voltage at the socket outlet

•

whether there is good contact at the charging

contacts

If the battery pack still fails to charge, send

•

the charging unit

•

and the battery pack

to our customer service center.

To ensure that the battery pack provides long ser-

vice, you should take care to recharge it promptly.

You must recharge the battery pack when you

notice that the power of the cordless grass trim-

mer drops. Never fully discharge the battery pack.

This will cause it to develop a defect.

6. Operation

To obtain maximum performance from your grass

trimmer, please follow these instructions:

•

Never use the grass trimmer without the

guard.

•

Do not mow grass when it is wet. The best

results are achieved with dry grass.

•

To switch on your grass trimmer, press the

safety lock-off (Fig. 2 / Item 1) and the On/Off

switch (Fig. 2 / Item 2).

•

To switch off your grass trimmer, let go of the

On/Off switch again (Fig. 2 / Item 2).

•

Do not allow the grass trimmer near the grass

until the switch is pressed, i.e. the grass trim-

mer is in operation.

•

To cut properly, swing the machine sideways

while moving forwards. Keep the grass trim-

mer inclined at an angle of approx. 30° while

you do so (see Figs. 17 and 18).

•

If the grass is long, the grass must be cut

shorter in stages, starting from the tip (see

Fig. 19).

•

Use the guard hood to prevent unnecessary

wear.

•

To avoid unnecessary wear, keep the grass

trimmer away from hard objects.

Using the grass trimmer as an edge trimmer

To cut the edges of lawns and ﬂ ower beds, the

grass trimmer can be converted as follows:

•

Remove the battery pack

•

Pull the lock for the rotatable motor head in

the direction of the arrow as shown in Fig. 13.

•

Turn the motor head through 90° in the requi-

red direction until it latches in place (Fig. 14).

•

Now you have converted the grass trimmer to

an edge trimmer for cutting the lawn vertically.

•

To convert the equipment back to its original

state, proceed in reverse order.

Anl_GE_CT_18_Li_Kit_SPK7.indb 23Anl_GE_CT_18_Li_Kit_SPK7.indb 23 27.01.15 15:5927.01.15 15:59

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Einhell GE-CT 18 Li Kit in the language / languages: English, German, Dutch, French, Italian, Swedish, Finnish as an attachment in your email.

The manual is 2,48 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Einhell GE-CT 18 Li Kit Manual

Product: