Manual Einhell GC-PM 51-2 S HW BS (page 23 of 164) (English, German, French, Italian, Portuguese, Swedish, Spanish, Norwegian)

605757

Zoom out

Zoom in

1/164

- 23 -

6.4 Emptying the debris bag

When the debris bag is full, the air throughput will

be low and the level indicator (4c) will be up close

against the debris bag (Fig. 10). Empty the debris

bag and clear out the ejector chute.

Danger! Before taking o the debris bag,

switch o the engine and wait until the blade

has come to a stop.

To take o the grass basket, use one hand to lift

up the chute ap and the other to grab onto the

basket carry-handle. Remove the basket (Fig. 4a).

For safety reasons, the chute ap automatically

falls down after removing the grass basket and

closes o the rear chute opening. If any grass

remains in the opening, it will be easier to restart

the engine if you pull the mower back approxi-

mately 1m.

Do not use your hands or feet to remove clippings

in or on the mower housing, but instead use suita-

ble tools such as a brush or a hand broom.

In order to ensure that the majority of grass clip-

pings are picked up, the inside of both the grass

bag and especially the air grill must be cleaned

after each use.

Reattach the grass bag only when the engine is

switched o and the blade is stopped.

Using one hand, lift up the chute ap, while grab-

bing onto the basket handle with the other. Hang

in the basket from the top.

7. Cleaning, maintenance, storage,

transport and ordering of spare

parts

Danger!

Never work on or touch any current-conducting

parts of the ignition system while the engine is

running. Pull the spark plug boot from the spark

boot before doing any maintenance or assembly

work. Never carry out any work on the equipment

while the engine is running. Work that is not de-

scribed in these operating instructions, should

only be carried out by authorized workshops.

7.1 Cleaning

The lawn mower should be cleaned thoroughly

every time after it has been used. This applies in

particular to its underside and the blade mount.

Tilt the lawn mower to the rear by pressing down

the push bar.

Note: Before tilting the lawn mower, use a petrol

extraction pump to drain all the fuel out of the

fuel tank. Do not tilt the lawn mower by more

than 90 degrees. It is easiest to remove dirt and

grass immediately after mowing. Dried grass

remnants and dirt may impair the mowing ope-

ration. Check whether the grass ejector chute is

free of grass residues and clear out as required.

Never clean the lawn mower using a water jet or a

high-pressure cleaner. Ensure that no water can

get into the interior of the equipment. Do not use

aggressive cleaning agents such as cold cleaners

or petroleum ether.

7.2 Maintenance

Note: Dispose of soiled maintenance material

and operating materials at the appropriate collec-

tion point.

7.2.1 Petrol engine

The enclosed engine manual from Briggs &

Stratton provides maintenance information

and maintenance interval information on the

engine.

7.2.2 Blades

For safety reasons, have all blade sharpening,

balancing and mounting work carried out by an

authorized service center. To achieve optimal re-

sults, we recommend having the blades checked

once a year.

Changing the blades (Fig. 8)

When changing the cutting unit, be sure to use

only genuine replacement parts. The identication

mark on the blade must correspond with the num-

ber specied in the spare parts list.

Never install a blade from a dierent manufactu-

rer.

Damaged blades

If, in spite of all caution, the blade comes into con-

tact with an obstacle, switch o the engine imme-

diately and pull o the spark plug connector.

Tilt the lawn mower to the rear and check the

blade for damage. Damaged or bent blades must

be replaced. Never straighten a bent blade. Never

work with bent or heavily worn blades as this will

Anl_GC_PM_51_2_SHWBS_SPK7.indb 23 23.09.14 10:26

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Einhell GC-PM 51-2 S HW BS in the language / languages: English, German, French, Italian, Portuguese, Swedish, Spanish, Norwegian as an attachment in your email.

The manual is 3,9 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Einhell GC-PM 51-2 S HW BS Manual

Product: