2. Layout (Fig. 1)
1 Carry-handle
2 Heat output switch
3 Thermostat control
4 Air outlet grille
5 Stand
6 Adjusting screw
7 Air inlet grille
8 Fan motor
3. Items supplied
n Open the packaging and take out the equipment
with care.
n Remove the packaging material and any
packaging and/or transportation braces (if
available).
n Check to see if all items are supplied.
n Inspect the equipment and accessories for
transport damage.
n If possible, please keep the packaging until the
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys. Do not let children play with plastic bags,
foils or small parts. There is a danger of
swallowing or suffocating!
n Electric heater
n Original Operating Instructions
4. Intended use
The equipment can be used indoors in a free
standing position. Keep a minimum distance of 1 m
between the housing and walls, combustible
materials (furniture, curtains, etc.). The equipment
may only be used completely mounted and standing
vertically on a stable surface. It is prohibited to
operate the equipment on an instable surface (e.g. on
a bed).
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
5. Technical data
Rated voltage: 230 V ~ 50 Hz
Heat output: 3000 W (1500 W / 3000 W)
Thermostat control: Infinitely adjustable
Protection type: IP24
Equipment dimensions approx.: 32 x 30 x 25 cm
6. Before starting the equipment
Important! Before using the equipment for the first
time, check that the voltage supply is the same as the
voltage details set out on the rating plate.
Read the safety regulations in section 1.
n Check the correct air throughput by holding a
sheet of paper a distance of 10 cm in front of the
air outlet grille in air circulation mode (without
heating). The paper must be blown away from the
air outlet grille.Check the correct air throughput by
holding a sheet of paper a distance of 10 cm in
front of the air outlet grille in air circulation mode
(without heating). The paper must be blown away
from the air outlet grille.
n When the equipment is used for the first time or
after a long period of rest it may emit an odor for
a short time. This is not a fault.
n Because the heating system works with specially
encapsulated heating elements and a high air
delivery rate, the emitted air may be felt to be
cooler than that from a conventional fan heater.
This is not an equipment defect.
6.1 Assembly (Fig. 2)
Secure the housing to the stand (5) on both sides
using the M8 x 28mm screws (a). Then insert the
adjustment screws (6) through the slots provided on
both sides of the stand, thus fixing the housing in
place.
Fasten the carry-handle to the housing using the four
3.5x10mm self-tapping screws (b).
6.2 Setting the angle (Fig. 3)
By slightly slackening the adjustment screws (6) you
can swing up the housing from the horizontal through
a maximum angle of approx. 20°. Then retighten the
adjustment screws securely.
10
GB
