protection is not used (hearing loss)
n Inhalation of abrasive particles from the material
and wheel
n Electric shock upon contact with non-insulated
electrical parts
If the instructions listed in the operating instructions
are not adhered to, improper handling of the
equipment may result in other residual risks
5. Technical data
Voltage: 230-240 V ~ 50 Hz
Power rating: 1100 W
Speed: 1000-3500 min
-1
Polishing / sanding disk diameter: 180 mm
Connection thread: M14
Totally insulated II/ 쓑
Weight: 2.4 kg
Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745-2-3.
L
pA
sound pressure level 88.8 dB(A)
K
pA
uncertainty 3 dB
L
WA
sound power level 98.8 dB(A)
K
WA
uncertainty 3 dB
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745-2-3.
Vibration emission value a
h/DS
= 3,945 m/s
2
K uncertainty = 1,5 m/s
2
Operating mode: Sanding with sanding paper
Vibration emission value a
h/P
= 2,8 m/s
2
K uncertainty = 1,5 m/s
2
Operating mode: Polishing
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with another electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Danger!
Keep the noise emissions and vibrations to a
minimum.
n Only use appliances which are in perfect working
order.
n Service and clean the appliance regularly.
n Adapt your working style to suit the appliance.
n Do not overload the appliance.
n Have the appliance serviced whenever
necessary.
n Switch the appliance off when it is not in use.
n Wear protective gloves.
6. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
6.1 Assembly (Fig. 6)
Pull out the mains power plug before starting the
assembly work.
7. Using the equipment
Secure your workpiece. Make sure that the
workpiece is held securely by a clamping device or a
vise.
7.1 Switching the equipment ON/OFF
The equipment is turned on (I) and off (0) with the
ON/OFF switch (Fig. 3 / Item 3). However, the
equipment will only start running after the speed
control has been activated (see section 7.4).
7.2 Using as a polishing machine
When using waxing and polishing agents,
observe the instructions issued by their
manufacturer!
IMPORTANT!
To prevent damage to the surfaces of the workpieces
you wish to polish, make sure that you observe the
following instructions:
n Make sure that the polishing attachment is always
mounted precisely in the center of the
sanding/grinding disk.
12
GB
