11
GB
4. Technical data
Speed n
0
: 950 rpm
Cutting width of the grass cutter: 70 mm
Cutting width of the shrub shears 100 mm
Cutting thickness of the shrub shears 8 mm
Running time max.: 60 min
Battery pack: Li-Ion / 3,6 V d. c. / 1.3 Ah
Charging time: 3-5 h
Protection class: III
L
pA
sound pressure level: 72.7 dB
L
WA
sound power level: 92.9 dB
Vibration a
hV
grass shears: ≤ 2.5m/s
2
Vibration a
hV
shrub shears: 5.5m/s
2
Weight: 1.4 kg
Battery charger
Mains voltage 230 V ~ 50 Hz
Output
Rated voltage 6 V DC
Rated current: 300 mA
Sound and vibration were measured in accordance
with EN ISO 3744.
5. Before starting
5.1 Charging the battery pack (Figure 1, 3)
Ȝ Connect the charger to the charging station
(Figure 5).
Ȝ Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger. Plug the battery charger in a socket-
outlet. The red LED (Figure 5 / Item 1) comes on
to indicate that charging voltage is available.
Ȝ The battery pack is being charged. An empty
battery pack requires a maximum charging period
of 3 to 5 hours. The temperature of the battery
pack may rise slightly during the charging
operation. This is normal.
Ȝ As soon as battery pack is fully charged, the red
LED (Fig. 5/Item 1) extinguishes
If the rechargeable battery fails to charge, check
whether there is voltage at the socket outlet.
Timely recharging of the battery pack will help it
serve you well for a long time. Recharging is always
necessary when you notice a drop in the toolʼs
performance.
Never allow the battery pack to become fully
discharged. This will cause it to develop a defect.
5.2 Fitting the long handle
Using the telescopic long handle (Fig. 1/Item 5) you
can push the cordless shears on wheels over the
lawn.
To fit the long handle, push the mount (Fig. 3a/Item 8)
onto the long handle until the lock engages in one of
the recesses on the mount. The equipment is
provided with one recess at the top for standard
cutting and two recesses on the left and right for
cutting edges. Now pass the wheels (Fig. 3b/Item 2)
through the axle mount and plug together.
Undo the clamp coupling (Fig. 1/Item 6), adjust the
telescopic handle to the required length and then re-
tighten the clamp coupling again. Now push the
equipment in the direction indicated by the arrow into
the mount (Fig. 4a/Item 8) as shown in Figure 4a.
Ensure that the mount locks into the recesses
correctly. Then connect the power plug (Fig. 4b/Item
1) to the equipment as shown in Figure 4b. To
disassemble, proceed in reverse order.
Important!
It is prohibited to remove or bridge any of the
switching elements installed on the tool by the
manufacturer (e.g. by securing a button to the
handle) as this would prevent the tool from
switching off automatically and result in high risk
of injury.
Under no circumstances are you to use the shrub
cutter with the telescopic long handle fitted.
