Manual Eglo Antibes 35014 (page 26 of 80) (English, German, Dutch, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Finnish)

756432

Zoom out

Zoom in

1/80

ANTIBES Ceiling Fan

Position auswählen

1. Der Deckenventilator muss so installiert werden, dass die Flügel einen Mindestabstand von 300mm von der Flügelspitze zu den

nächstgelegenen Objekten oder Wänden aufweisen.

2. Der Deckenventilator muss so installiert werden, dass sich die Flügel mindestens 2,3m über dem Boden befinden.

3. Der Befestigungspunkt für Ihren Ventilator muss eine Tragkraft von mindestens 45kg aufweisen. Wenn der Standort keinen stabilen

Montagepunkt hat, müssen Sie eine Holzstütze zwischen zwei Deckenbalken installieren. Siehe Abb. 2.

Montage der Aufhängehalterung:

4. Montieren Sie die Aufhängehalterung mit den mitgelieferten langen Schrauben am Deckenbalken oder an der Holzstütze. Führen Sie

die Schrauben durch die Langlöcher in der Hängevorrichtung und befestigen Sie sie an der Decke. Siehe Abb. 3

5. Achten Sie darauf, dass mindestens 30 mm der Schraube in den Deckenbalken oder die Holzstütze eingeschraubt sind.

Hinweis: Der Befestigungspunkt MUSS eine Tragkraft von 45 kg aufweisen. Das Bild dient nur zur Darstellung und stellt nicht die

tatsächliche Halterung dar.

Hinweis: Die mitgelieferten Befestigungsschrauben sind für die Verwendung mit Holzdeckenbalken vorgesehen, für alle anderen

Materialien müssen die entsprechenden Befestigungsschrauben gekauft werden.

Hinweis: Die Aufhängehalterung Ihres Ventilators ermöglicht die Montage an abgewinkelten/abgeschrägten Decken bis zu einer Neigung

von 14 Grad.

Selecting a location

1. The ceiling fan must be installed in a location so that the blades are a minimum 300 mm spacing from the tip of the blade, to the

nearest objects or walls.

2. The ceiling fan must be installed in a location so that the blades are a minimum 2.3 m above the floor.

3. The fixing point for your ceiling fan must be capable of supporting a 45 kg load. If the location does not have a solid mounting point,

you will need to install a timber support between two ceiling joists. Refer to Figure 2.

Installing the hanging bracket

4. Install the hanging bracket to the ceiling joist or timber support with the long installation screws provided. Pass the screws through

the slotted holes in the hanging bracket and secure to the ceiling. Refer to Fig. 3

5. Ensure that at least 30 mm of the screw is threaded into the ceiling joist or timber support.

Note: The xing screws included are designed for use with timber ceiling joists, for all other materials, the appropriate xing screws will

need to be purchased.

Note: Your fans hanging bracket allows for mounting on angled/sloped ceilings up to a 14-degree pitch.

Note: The use of electric drivers can overtighten the screws and damage threads, DO NOT use power tools for tightening screws.

Список деталей

1. Подвесной кронштейн / 2. Приемник / 3. Колпак / 4. Подвесной шарик / 5. Штанга / 6. Соединительная крышка / 7. Корпус двигателя / 8. Вилка /

9. Кронштейн крышки / 10. Двигатель постоянного тока / 11. Лопасти / 12. Светильник / 13. Пульт дистанционного управления

Необходимые инструменты: Крестообразная отвертка Phillips, Отвертка с плоским шлицем, Пассатижи, Кусачки, Лестница,

Питающий кабель

Примечание: Использование электри- ческих отверток может привести к перезатяжке и повреждению резьбы — не исполь- зуйте

для затяжки винтов приводные инструменты.

Spisak delova

1. Viseći držač / 2. Prijemnik / 3. Maska / 4. Viseća kugla / 5. Silazna šipka / 6. Maska za spojnicu / 7. Kućište motora / 8. Prstenast okov /

9. Maska držača / 10. Motor jednosmerne struje / 11. Lopatice / 12. Pribor za svetlo / 13. Daljinski upravljač

Potrebni alati: Krstasti šrafciger, Ravan šrafciger, Klešta, Sekač žice, Merdevine, Kabl za napajanje

Napomena: Upotrebom električnih šralica, šrafovi se mogu previše pritegnuti i tako oštetiti navoji, tako da NE KORISTITE električni alat za

zatezanje šrafova.

Lista części

1. Uchwyt wieszaka

2. Odbiornik

3. Osłona

4. Element kulisty wieszaka

5. Pręt wydłużający

6. Pokrywa sprzęgu

Obudowa silnika

8. Jarzmo

9. Wspornik pokrywy

10. Silnik prądu stałego

11. Łopatki

12. Zestaw oświetleniowy

13. Pilot zdalnego sterowania

Wymagane narzędzia: Śrubokręt krzyżakowy, Śrubokręt płaski, Kombinerki, Szczypce do cięcia drutu, Drabina, Kabel zasilający

Uwaga: Użycie wkrętaków elektrycznych może skutkować zbyt silnym dokręcaniem śrub iniszczeniem ich gwintów; NIE WOLNO używać

elektronarzędzi do dokręcania śrub.

Fig. 2 Fig. 3

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Eglo Antibes 35014 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Finnish as an attachment in your email.

The manual is 5,65 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Eglo Antibes 35014 Manual

Product: