571150
10
Zoom out
Zoom in
Previous page
1/27
Next page
395823110a 10
7. Check that all clearances are still within the allowable tolerances.
8. Secure adjoining sections of chimney connector to each other using three
equally spaced sheet metal screws. Secure the connector pipe to flue collar
using three equally spaced sheet metal screws. DO NOT secure chimney
connector to chimney with screws.
DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERVING ANOTHER
APPLIANCE.
9. The unit must be connected to either:
a code-approved masonry chimney with a flue liner, or
a 6 inch diameter factory built chimney complying with the requirements
for Type HT chimneys in the standard UL 103.
Minimum Chimney Height
American National Standards Institute ANSI/NFPA 211-92, draft 1-7 states that a
chimney or vent shall be so designed and constructed to develop a flow sufficient
to completely remove all flue and vent gases to the outside atmosphere. The
venting system shall satisfy the draft requirements of the connected appliance in
accordance with the manufactures instructions.
The “3-foot, 2-foot, 10-foot rule” on chimney height states that a chimney must be:
1. at least 3 feet higher than the highest part of the roof opening through which it
passes,
2. and at least 2 feet higher than any part of the roof within 10 feet, measured
horizontally.
2'
10'
3'
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Efel STANFORD 80 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Efel STANFORD 80 in the language / languages: English as an attachment in your email.

The manual is 2,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info