644134

Efco MT6500 Manual

12
Zoom out
Zoom in
Previous page
1/68
Next page
1 2 3 44
Italiano
MONTAGGIO BARRA E CATENA
- Tirare la protezione (Fig. 1) verso l’impugnatura
anteriore per verificare che il freno catena non sia
inserito.
- Togliere i dadi (A) e smontare il carter copricatena
(B, Fig. 2).
- Eliminare lo spessore in plastica inserito sui
prigionieri barra (C, Fig. 3).
- Portare il nottolino tendicatena (D, Fig. 3) a
finecorsa, svitando tutta la vite tendicatena (L).
- Inserire la barra (F, Fig. 3) sui prigionieri (N).
- Montare la catena (H, Fig. 4) dentro al rocchetto (E)
ed alla guida della barra (M). Fare attenzione al
senso di rotazione della catena (Fig. 6).
- Appoggiare il carter copricatena, inserendolo
nell’apposito alloggiamento e, tenendolo premuto
contro la barra, avvitare la vite tendicatena (L, Fig.
5), affinché il nottolino (D, Fig. 3) entri nel foro (G)
della barra.
- Montare il carter copricatena ed i relativi dadi senza
serrarli.
- Tendere la catena per mezzo della vite tendicatena
(L,Fig.5).
- Serrare definitivamente i dadi di fissaggio del carter
copricatena tenendo sollevata la punta della barra
(Fig. 7).La catena deve essere regolata in modo che
sia ben tesa e possa scorrere facilmente con la
forza della mano (Fig. 8).
- La catena è regolata alla giusta tensione quando la
si può sollevare di qualche millimetro tirandola verso
l’alto (Fig. 8).
ATTENZIONE - Controllare più volte la tensione
della catena durante l’uso giornaliero della
motose
g
a. Utilizzare sem
p
re
g
uanti
p
rotettivi.
English
FITTING THE BAR AND CHAIN
- Pull the guard (Fig. 1) towards the front handle to
check that the chain brake is not on.
- Remove the bar nuts (A) and the chain cover (B,
Fig. 2).
- Remove and discard the plastic shim from the
bar studs (C, Fig. 3).
- Take the chain tightener pawl (D, Fig. 3) to the
limit stop, by unscrewing all the chain tightener
screw (L).
- Place the bar (F, Fig. 3) onto the studs (N).
- Fit the chain (H, Fig. 4) inside the sprocket (E)
and the bar groove (M). Pay attention to the
direction of rotation of the chain (Fig. 6).
- Put down the chain cover, inserting it into its
housing and, keeping it pressed against the bar,
screw on the chain tightener screw (L, Fig. 5) so
that the pawl (D, Fig. 3) goes into the hole (G) of
the bar.
- Fit the chain cover and the relative nuts without
tightening them.
- Tension the chain by means of the tensioning
screw(L,Fig.5).
- Hold the tip of the guide bar up and tighten the
chain cover nuts securely (Fig. 7). The chain
should be taut but turn freely by hand (Fig. 8).
- The chain is tensioned correctly when it can be
pulled upwards a few millimetres (Fig. 8).
WARNING - Check the chain tension
frequently when operating the chainsaw.
A
lways use protective gloves.
Français
MONTAGE GUIDE ET CHA
Î
NE
- Tirez la protection (Fig.1) en direction de la poignée
antérieure pour vérifier que le frein de cha
î
ne n’est
pas enclenché.
- Otez les écrous (A) et démontez le carter de cha
î
ne
(B, Fig.2).
- Eliminez l’épaisseur en plastique calée sur les
prisonniers du guide (C, Fig.3).
- Placez l'encliquetage tendeur de cha
î
ne(D,Fig.3)
en fin de course, en dévissant toute la vis du
tendeur de cha
î
ne (L).
- Placez le guide (F, Fig. 3) sur les prisonniers (N).
- Montez la cha
î
ne (H, Fig. 4) dans le pignon (E) et à
la rainure du guide (M). Faites attention au sens de
rotation de la cha
î
ne (Fig. 6).
- Posez le carter de la cha
î
ne en l'encastrant à sa
place et, en le tenant bien appuyé contre la barre,
vissez la vis du tendeur de cha
î
ne(L,Fig.5)afin
que l'encliquetage (D, Fig. 3) entre dans le trou (G)
de la barre.
- Montez le carter protège-cha
î
ne et les écrous
correspondants sans les serrer.
- Tendez la cha
î
ne à l’aide de la vis de tension de la
cha
î
ne (L, Fig.5).
- Serrez définitivement les écrous de fixation du
carter protège-cha
î
ne en soulevant la pointe de
guide (Fig.7). La cha
î
ne doit être réglée, c’est à dire
bien tendue et à même de glisser facilement sous la
pression de la main (Fig.8).
-Lacha
î
ne est correctement tendue lorsque vous
pouvez la soulever de quelques millimètres (Fig. 8).
ATTENTION - Contrôlez souvent la tension de la
chaîne pendant l’utilisation de la tronçonneuse.
Utilisez tou
j
ours des
g
ants de
p
rotection.
12
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Efco MT6500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Efco MT6500 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 4,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info