644116

Efco DS2800 Manual

52
Zoom out
Zoom in
Previous page
1/68
Next page
52
Italiano FrançaisEnglish
RIMESSAGGIO REMISSAGESTORAGE
RIMESSAGGIO
Quando la macchina deve rimanere ferma per lunghi
periodi:
- Vuotare e pulire il serbatoio carburante in un luogo ben
ventilato. Per vuotare il carburatore, avviare il motore e
attenderne l’arresto (lasciando la miscela nel
carburatore le membrane potrebbero danneggiarsi).
- Le procedure di messa in servizio dopo un rimessaggio
invernale sono le stesse che si effettuano durante l’avvio
normale della macchina (pag. 18-26).
- Seguire tutte le norme di manutenzione precedentemente
descritte.
- Pulire perfettamente il decespugliatore e ingrassare le
parti metalliche.
- Togliere il disco, pulirlo ed oliarlo per prevenire la
ruggine.
- Togliere le  ange ferma disco; pulire, asciugare ed oliare
la sede coppia conica (Fig. 100).
- Togliere il carburante dal serbatoio e rimontare il
tappo.
- Pulire accuratamente le feritoie di raffreddamento
(Fig. 101) e il  ltro aria (Fig. 102).
- Conservare in ambiente secco, possibilmente non a diretto
contatto con il suolo e lontano da fonti di calore.
REMISSAGE
Lorsque l’appareil doit être stocké pendant de longues
périodes:
- Vidanger et nettoyer le réservoir de carburant dans un
lieu bien aéré. Pour vider le carburateur, démarrer le
moteur et en attendre l’arrêt (le fait de laisser du
mélange dans le carburateur pourrait endommager les
membranes).
- Les procédures de mise en service après un remisage
hivernal sont les mêmes que pour le démarrage normal
de la machine (page 18-26).
- Suivez toutes les règles d'entretien décrites cidessus.
- Nettoyez parfaitement la débroussailleuse et graissez les
parties en métal.
- Otez le disque, nettoyez-le et lubri ez -le a n d'éviter qu'il
ne rouille.
- Enlevez la bride de blocage du disque, nettoyez, essuyez
et lubri ez le siège du couple conique (Fig. 100).
- Otez le carburant du réservoir et remontez le bouchon.
- Nettoyer à fond les fentes de refroidissement (Fig. 101)
et le  ltre de l'air (Fig. 102).
- Conservez l'appareil dans un endroit sec, si possible
soulevé du sol et loin des sources de chaleur.
STORAGE
If the machine is to be stored for long periods:
- Drain and clean the fuel tank in a well-ventilated area.
To drain the tank, start the engine and wait until the
fuel is exhausted and the engine stops (leaving fuel
mixture in the carburettor could damage the
membranes).
- The procedures for returning the machine to service
following winter storage are the same as for starting up
during everyday use (page 18-26).
- Follow all the maintenance regulations previously
described.
- Clean the brush cutter completely and lubricate the
metallic parts.
- Remove, clean and lubricate the blade to prevent
rusting.
- Remove the blade  xing  anges, clean, dry and lubricate
the bevel gear seat (Fig. 100).
- Empty the fuel tank and put the cap back on.
-  oroughly clean the cooling slots (Fig. 101) and the air
lter (Fig. 102).
- Store the brush cutter in a dry place, preferably not in
direct contact with the  oor and away from heat sources.
100 101
102
… 52 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Efco DS2800 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Efco DS2800 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info