644133

Efco 165HDS Manual

36
Zoom out
Zoom in
Previous page
1/68
Next page
72 73 74 75
Italiano
MANUTENZIONE
FILTRO ARIA - Sganciare i fermi del coperchio (A, Fig.72), svitare
le viti del filtro aria (D, Fig.72) e controllare giornalmente il filtro aria
(B). Aprire il filtro (B) agendo sulle due linguette (E, Fig.73). Pulire
con sgrassante Emak cod. 001101009A, lavare con acqua e
soffiare a distanza con aria compressa dall'interno verso l'esterno.
Sostituire il filtro se è fortemente intasato o danneggiato.
FILTRO CARBURANTE - Verificare periodicamente le condizioni
del filtro carburante. In caso di sporcizia eccessiva, sostituirlo (Fig.
74).
POMPA OLIO (automatica regolabile) - La portata è preregolata di
fabbrica. L’erogazione dell’olio può essere variata dall’operatore, a
seconda delle esigenze, tramite l’apposita vite di registro (Fig. 75).
La portata dell’olio avviene solo con la catena in movimento.
ATTENZIONE - Non utilizzare mai olio di recupero.
GRUPPO AVVIAMENTO - Tenere libere e pulite le feritoie di
raffreddamento del carter gruppo avviamento con pennello o aria
compressa.
MOTORE / VALVOLA DI DECOMPRESSIONE - Pulire
periodicamente le alette del cilindro con pennello o aria compressa
(Fig. 76). L’accumulo di impurità sul cilindro può provocare
surriscaldamenti dannosi per il funzionamento del motore.
Controllare e pulire eventuali impurità alla base della valvola di
decompressione; potrebbe rimanere aperta.
CANDELA - Periodicamente si raccomanda la pulizia della candela
e il controllo della distanza degli elettrodi (Fig. 77).
Utilizzare candela Champion RCJ-4 o di altra marca di grado
termico equivalente.
FRENO CATENA - Nel caso il freno catena non funzioni
correttamente, smontare il carter copricatena e pulire a fondo i
componenti del freno. Quando il nastro del freno catena è usurato
e/o deformato, sostituirlo (A, Fig. 78).
Verificare e sostituire se necessario, l’arresto di sicurezza della
catena(B,Fig.78).
BARRA - Ruotare la barra e verificare che i fori di lubrificazione
siano libe
r
idaimpu
r
ità
(
Fi
g
.79
)
.
English
MAINTENANCE
AIR FILTER - Unclip the cover fasteners (A, Fig.72), undo the
air cleaner screws (D, Fig.72) and check air cleaner (B) on a
daily basis. Open air cleaner (B) by means of the two tabs (E,
Fig.73). Clean with Emak degreaser p/n 001101009A, rinse
with water and blast dry with compressed air, not too close,
blowing from the inside outwards. Renew the filter if heavily
clogged or damaged.
FUEL FILTER - Check the fuel filter periodically. Replace it if
too dirty (Fig. 74).
OIL PUMP (automatic/ad
j
ustable) -Flowad
ustment is pre-set
by the manufacturer. Oil flow can be ad
usted by the operator
according to specific requirements by means of the special
ad
usting screw (Fig. 75). Oil flow occurs only when the chain
is moving.
WARNING - Never use scavenge oil.
STARTING UNIT - Use a brush or compressed air to keep the
cooling louvers of the starter assembly free and clean.
ENGINE / DECOMPRESSION VALVE - Clean the cylinder fins
(Fig. 76) with compressed air or a brush periodically
.
Dangerous overheating of engine may occur due to impurities
on the cylinder.
Check the base of the decompression valve; clean away any
residues, which could cause the valve to stay open.
SPARK PLUG - Clean the spark plug and check the electrode
gap periodically (Fig. 77).
Use Champion RCJ-4 or of other brand with the same thermal
grade.
CHAIN BRAKE - If the chain brake does not work properly,
remove the chain cover and the clean brake components
.
Replace the chain brake band if worn or deformed (A, Fig. 78).
Check and, if necessary, replace the chain safety stop (B, Fig
.
78).
GUIDE BAR - Turn the guide bar and check that the lubrication
holes are
f
ree
f
rom impurities
(
Fi
g
.79
)
.
Français
ENTRETIEN
FILTRE A AIR - Décrocher les dispositifs d'arrêt du couvercle (A,
Fig.72), desserrer les vis du filtre de l'air (D, Fig.72) et contrôler
quotidiennement le filtre de l'air (B). Ouvrir le filtre (B) en
intervenant sur les deux languettes (E, Fig.73). Nettoyer avec du
dégraissant Emak cod. 001101009A, laver avec de l'eau et souffler
à distance avec de l'air comprimé de l'intérieur vers l'extérieur.
Remplacer le filtre s'il est fortement colmaté ou endommagé.
FILTRE CARBURANT - Vérifiez périodiquement les conditions du
filtre carburant; s’il est trop sale, mieux vaut le changer. (Fig.74).
POMPE A HUILE (automatique réglable) - Le débit est préréglé à
l’usine. L’opérateur peut varier la distribution de l’huile selon les
exigences, au moyen de la vis de réglage (Fig.75). Il n’y a débit
d’huile que lorsque la chaîne est en mouvement.
ATTENTION - N’utilisez
amais d’huile de récupération.
GROUPE DEMARREUR - Veillez à ce que les fentes de
refroidissement du carter du groupe démarreur soient tou
j
ours
dégagées. Utilisez un pinceau ou de l’air comprimé.
MOTEUR / VALVE DE DECOMPRESSION - Nettoyez
régulièrement les ailettes du cylindre à l’aide d’un pinceau ou d’air
comprimé (Fig. 76). L’accumulation d’impuretés sur le cylindre
peut provoquer des surchauffes nuisibles au bon fonctionnement
du moteur.
Contrôler et nettoyer les impuretés éventuelles qui se seraient
déposées à la base de la valve de décompression; celle-ci pourrait
rester ouverte.
BOUGIE - Il est recommandé de nettoyer périodiquement la
bougie et de contrôler la distance entre les électrodes (Fig.77).
Utiliser une bougie Champion RCJ-4 ou autre marque avec degré
thermique équivalent.
FREIN DE CHAINE - Si le frein de chaîne ne fonctionne pas bien,
démontez le carter protège-chaîne et nettoyez à fond les éléments
du frein. Lorsque le ruban du frein de chaîne est usé et/ou
déformé, remplacez-le (A, Fig.78).
Vérifiez et, si cela s’avère nécessaire, remplacez l’arrêt de sûreté
de la chaîne (B, Fig.78).
GUIDE - Tournez le guide et vérifiez que les trous de lubrification
sont dé
g
a
g
és d’éventuelles impu
r
etés
(
Fi
g
.79
)
.
36
… 36 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Efco 165HDS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Efco 165HDS in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 4,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info