398099

Efbe-schott lt 52 Manual

5
Zoom out
Zoom in
Previous page
1/12
Next page
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
5
Assembly page 5/5
Fax +32 2 359 95 50
SPECIAL ATTENTION
Your new appliance is designed with a protective coating around the heating coils. When
plugged in and operating for the first time, there may be a little momentary smoking while this
coating is initially heated. This presents no danger to the user and does not indicate a defect in
the unit. When using for the first time, allow the appliance to continue running until the smoke
dissipates. This should last only about 30 seconds.
OPERATION
The hair drying hood has two power settings.
0 – OFF
I – 180 W
II – 320 W
Before using the appliance, attach the hood to the main unit. The main unit is to be inserted in
the opening of the hood. Then pass the rubber ring situated in the edge of the hood over the
unit till it arrives in the fixing slot. After checking whether the rubber ring is correctly attached,
attach the flexible hood to the bottom of the main unit by attaching the press-stud. The
appliance is now ready for use.
When using the appliance, always let the flexible hood hang down.
CLEANING AND CARE
Unplug the appliance and let it cool down. Use a cloth to clean the hair drying hood. Make
sure does not become wet. If the air intake opening is dirty, please clean it.
When cleaning or repairing the appliance, we advise you to remove the flexible hood from the
main unit. To detach the flexible hood from the main unit, release the press-stud by pulling at
the tongue situated next to the press-stud inside the hood and take the rubber ring off the slot.
The textile hood is washable at 30°C.
AFTER USE
Unplug the appliance, let it cool down and store it. Never wrap the cord tightly around the
appliance. Never hang unit by the cord. Never pull at the cord, as this could damage the
appliance.
CUSTOMER SERVICE
efbe Elektrogeräte GmbH
Gustav-Töpfer-Strasse 6
07422 Bad Blankenburg / Thüringen
Germany
Tel : 00 49 36741 70268
Fax: 00 49 36741 70227
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Efbe-schott lt 52 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Efbe-schott lt 52 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 0,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info