726249

Edy EDTK5507 Manual

26
Zoom out
Zoom in
Previous page
1/30
Next page
23
B
efore you start
• This appliance has a heavy weight. Be careful when transporting it.
• Do not lift the appliance b
y the pipes or the door when moving.
• This appliance must stand vertically on a flat, even surface, to level the appliance use the
leveling feet by turning them until the appliance is as level as possible.
• Do not install onto carp
eted surfaces as this prevent adequate ventilation.
• Install the appliance in a w
ell ventilated room. The appliance should not be placed near to
any heat sources (cookers, heaters etc.) or in any unheated rooms (garages, outhouses etc.) as
the ambient temperature affects the performance of the appliance.
• P
arts that become hot must never be exposed. The back of the appliance must therefore be
placed against the wall not forgetting the customary distance for ventilation. Allow 300 mm
clearance at the rear of the appliance and on each side of the appliance and over the top to
ensure proper ventilation.
• Do not e
xpose the appliance to damp conditions, open air or rain.
• After y
ou remove all of the packaging materials, clean the inside of your refrigerator before
using it.
• Should the appliance b
ecome damaged, contact the service center and do not use the
appliance until y
ou are instructed to do so by a service engineer.
Getting star
ted
Once you have installed your appliance in an appropriate location, follow the start up procedure
below:
• Before you plug in the appliance, clean thoroughly the inside and all accessories.
• Leav
e the appliance to stand for 2 - 3 hours to allow the refrigerant to settle following instal-
lation and cleaning.
• If the appliance has been transported horizontally, it must be left to stand vertically for 12
hours before installation.
• Once dry, plug the appliance into the socket. Make sure the voltage of this appliance is in
accordance with the voltage of your energy grid.
• Turn the thermostat to the required setting.
• When using the freezer for the first time or after defrosting, set the thermostat knob to the
maximum position for at least 2 hours before introducing food to be stored, and then adjust it
to the normal position.
Temperature control
The temperature selector knob is located on the right hand side wall of the refrigerator interior.
The temperature of the chamber is adjusted through the thermostat knob. The numbers 1, 2, 3,
4, 5, 6, do not mean a specific temperature, the lower the number is, the higher the temperature
inside will be and vice versa.
During high ambient temperatures e.g. on hot summer days, it may be necessary to set the
thermostat to the coolest setting (position”Max”).This may cause the compressor running con-
tinuously in order to maintain a low temperature in the cabinet.
The first time you install your refrigerator, set the thermostat knob at “Med”. Give your refrigerator
time to cool down completely before adding food. Wait 24 hours before adding food.
The thermostat knob controls the temperature. When the thermostat control knob is set to OFF,
the refrigerator will not be running.
GB
… 26 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Edy EDTK5507 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Edy EDTK5507 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info