726229
83
Zoom out
Zoom in
Previous page
1/87
Next page
Replacing the LED light:
Warning: The LED light should be
replaced by a competent person! If the
LED light is damaged, contact the
customer helpline for assistance.
unplug the appliance from the mains
power and leave the doors open. Ventilate
the room thoroughly to accelerate the
thawing process.
2. When defrosting is completed, clean
your freezer as described above.
Caution! Don't use sharp objects to
remove frost from the freezer
compartment. Only after the interior is
completely dry should the appliance be
switched back on and plugged back into
the mains socket.
Door seals cleaning
Take care to keep door seals clean. Sticky
food and drinks can cause seals to stick
to the cabinet and tear when you open the
door. Wash seal with a mild detergent and
warm water. Rinse and dry it thoroughly
after cleaning.
Caution! Only after the door seals are
completely dry should the appliance be
powered on.
17
Defrosting
Why defrosting
Water contained in food or getting into air
inside the fridge be opening doors may
form a frost layer inside. It will weaken the
refrigeration when the frost is thick. While
it is more than 10mm thick, you should
defrost.
Defrosting in fresh food storage
compartment
It is automatically controlled by switching
the temperature regulator on or off so that
there is no need of operation of
defrosting. Water from defrosting will be
drained into an drip tray through a drain
pipe at the back of the fridge
automatically.
Defrosting in
compartment
frozen-food storage
Defrosting in freezer chamber is operated
manually. Before defrosting, take the food
out.
Take the ice tray and food in drawers out
or put them into the fresh food
compartment temporarily.
Set the knob of the temperature regulator
to position “0”(where the compressor will
stop working) and leave the door of the
refrigerator open until ice and frost
dissolve thoroughly and accumulation at
the bottom of the freezer chamber. Wipe
off the water with soft cloth.
In the case of speeding up the process of
defrosting, you may put a bowl of warm
water (about 50°C) into the freezer
chamber, and scrape away the ice and
frost with a defrosting spatula. After doing
so, be sure to set the knob of the
temperature regulator to the original
position.
It is not advisable to heat the freezer
chamber directly with hot water or hair
dryer while defrosting to avoid
deformation of the inner case.
It is also not advisable to scrape off ice
and frost or separate food from the
containers which have been congealed
together with the food with sharp tools or
wooden bars, so as not to damage the
inner casing or the surface of the
evaporator.
Warning! Switching off the appliance
before defrosting, turn the temperature
regulator to position “0”.
Important! The fridge should be
defrosted at least every one month.
During the using process, if the door was
opened frequently or using the appliance
in the extreme humidity, we advise the
user to defrost every two weeks.
Go out of use for a long time
Remove all refrigerated packages.
Switch off the appliance by turning the
temperature regulator to position “0”.
Remove the mains plug or switch off or
disconnect the electricity supply.
Clean thoroughly (see section: Cleaning
and Care).
Leave the door open to avoid the build up
of odors.
Note: If the appliance contains freezer
compartment.
83


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Edy EDHC8059 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Edy EDHC8059 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 9,11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info