810729

Edilkamin Pellkamin 10 Manual

5
Zoom out
Zoom in
Previous page
1/32
Next page
- 33 -
ENGLISH
g. 1
F
A
B
C
D
E
G
H
GENERAL INFORMATION
PRINCIPLE OF OPERATION
PELLKAMIN is an insert that uses pellets as fuel. Combustion
is electronically managed.
The combustion chamber is made with steel perimeter structure
covered, at the back, with a cast-iron panel and closed, at the
front, with a ceramic glass door (use the thermal glove pro-
vided when opening).
The fuel (pellets) is taken from the storage tank (A). A cochlea
(B) is enabled by a gear motor (C), which takes the fuel to the
combustion chamber (D).
The pellets are ignited by hot air produced by an electrical resi-
stance (E) and suctioned into the combustion chamber by
means of a centrifugal fan.
The smoke produced by combustion is extracted from the
hearth by means of this centrifugal fan and expelled from the
mouth located in the upper area of the insert (F).
Through the lower grille (G), the fans draw air from the room
that, routed through the cavity on the back of the combustion
chamber, is heated before returning to the room through the
upper grille (H).
Provide two aeration grilles (area larger than 100 cm2), the rst
one under the insert and the second positioned at least 50 cm
above the insert or anyway communicating with the internal
compartment where the insert is positioned, as indicated on
page 48.
The fuel tank (A) is situated to the rear of the insert.
The hopper can be lled in the following ways:
– through extraction of the insert, see page 42.
(TO BE CARRIED OUT ONLY WITH THE INSERT
TURNED OFF).
– using the pellet loading kit (optional), complete with loading
mouth to apply to the mantel, see page 43.
(THE INSTALLATION OF THE KIT ALLOWS PEL-
LETS TO BE LOADED IN THE HOPPER FROM THE
FRONT WITHOUT HAVING TO TURN OFF THE IN-
SERT).
– using the pellet front loading drawer kit (optional see page
46).
(INSTALLATION OF THE KIT MAKES IT POSSIBLE
TO LOAD THE PELLETS INTO THE HOPPER FROM
THE FRONT AND FROM THE SIDE WITHOUT HAV-
ING TO SHUT DOWN THE INSERT).
Fuel quantity, smoke extraction and combustion air supply
are all controlled by an electronic control board, which is
equipped with Leonardo software to achieve high combustion
ef ciency and low emissions.
All phases of operation can be managed via radio remote
control.
In case of breakage or loss of the radio remote control, switch-
ing on and off and setting the operating power can be done
through a 1,2-metre cable, complete with simplied on-button
to be placed near the insert by the installer (see page 53).
• Each time the insert is removed, a security system cuts off the
power supply. Should the insert be removed involuntarily du-
ring ignition, operation or while switching off (including while
blocked), the “Power failure” block phase will be launched
when the insert is reinserted. Wait for the block phase to end
before reactivating the insert.
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Edilkamin Pellkamin 10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Edilkamin Pellkamin 10 in the language / languages: English as an attachment in your email.

The manual is 4.57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Edilkamin Pellkamin 10

Edilkamin Pellkamin 10 Usermanual and installation guide - German - 28 pages

Edilkamin Pellkamin 10 Usermanual and installation guide - Dutch - 28 pages

Edilkamin Pellkamin 10 Usermanual and installation guide - French, Italian - 56 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info