810920
10
Zoom out
Zoom in
Previous page
1/44
Next page
10
ENGLISH
PLUMBING CONNECTION
The plumbing connection depends on the type of
system.
However, there are some “common rules”:
The plumbing connection must be carried out by
qualified personnel who can issue documentation
declaring correct installation conforming to current
law in each country (for example, in Italy according
to Ministerial Decree 37/2008 and standard UNI
10412-2)
The plumbing system must operate at a pressure
between 1 and 1.5-2 bar on a hot closed-vessel
circuit.
Note: DO NOT install the stove in place of, for
example, a thermocooker installed with an open
vessel without an adequate expansion system
making it a closed vessel.
The separation of the primary from the secondary
circuit is ideal and, in some countries, it is also
mandatory in case of the installation of a heating
plant (for example, in Italy, the reference is the
Circular from ISPESL, now INAIL, of April 2011).
This separation is easily carried out using KIT A2
from Edilkamin.
The presence of a puffer (inertial storage tank) is
recommended but not mandatory. Its presence
has the advantage of freeing the stove from
“sudden” demands from the heating system and
allowing the integration of other heat sources. It
reduces consumption and increases the efficiency
of the system.
The hot water exiting from the output of the stove
must be “directed” differently depending on the
objective (heating, radiators, exchanger, whether
or not there is a puffer, etc.)
• The material used in the circuit must be suitable
to withstand any overheating.
The discharge of the safety valve must be
accessible and visible. The discharge water must
be channelled into a vertical pipe using a funnel
with backflow air intakes, appropriately spaced
from the discharge point. The conveying pipe
must have the following characteristics:
Must not originate more than 50 cm from the
discharge of the valve and must be positioned in
the same room where the KIT
Verify that the hydraulic system is correctly
installed and is equipped with an expansion tank
that is sufficiently large to guarantee safety. The
presence of a tank within the boiler-stove does
NOT guarantee appropriate protection from
thermal expansion occurring in the whole system.
Therefore the installer must assess whether an
additional expansion tank is needed, depending on
the type of system installed.
Fill the system using the filling tap (it is recommended
not to exceed a pressure of 1,5 bar).
When filling, ‘bleed’ the pump and the relief tap.
PRESSURE GAUGE
Milla H has provided with an electronic reading system
for water pressure. Therefore, there is no analogue
pressure gauge. Water pressure is shown on the
display, on the bottom left (*) as indicated in the figure
below. Edilkamin proposes an analogue pressure
gauge as optional.
WATER CIRCUIT INSTALLATION
INSTALLER
(*)
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Edilkamin Milla H 15 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Edilkamin Milla H 15 in the language / languages: English as an attachment in your email.

The manual is 2.11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Edilkamin Milla H 15

Edilkamin Milla H 15 Usermanual and installation guide - German - 44 pages

Edilkamin Milla H 15 Usermanual and installation guide - Dutch - 44 pages

Edilkamin Milla H 15 Usermanual and installation guide - French, Italian - 84 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info