810817

Edilkamin Kelly Manual

47
Zoom out
Zoom in
Previous page
1/208
Next page
47
ENGLISH
CONTINUED: TINY model series radio remote control
RESERVE WARNING
The stove is fitted with an electronic function that detects the residual quantity of pellets in the tank.
The detection system is integrated into the electronic board, allowing you to see how many hours and kg are left until
pellet exhaustion, at all times. For correct system function, it is important that the following procedure is followed during
the first ignition (by the Dealer).
1st ignition/test by the Edilkamin authorised Dealer
Start-up must be carried out as prescribed by point 3.21 of standard UNI 10683.
This standard indicates the control operations to be carried out in situ, aimed at ascertaining correct system function.
Pellet reserve system
Before enabling the system, you need to load a sack of pellets into the tank and use the stove until the loaded fuel has
run out. This allows for a short system road test.
After this, the tank can be filled completely and the stove started up.
When running, at the time at which a whole 15 kg sack of pellets can be loaded, the display will show the word
“RESERVE” flashing.
At this point, after having poured in a sack of pellets, you need to 'inform' the memory that you have loaded 15 kg.
To do so, proceed as follows:
1.press the "M" key (for approximately 3-4 seconds) until the word “CLOCK” appears.
2.press the “+” key until the word “RESERVE” appears.
3.press the "M" key until the following screen appears,
then use the “+” key to take the figure (*) to the value equal to the Kg of pellets loaded (15 kg in the above example).
4.press the "M" key to confirm
5.press the key to exit.
After having completed the above procedure, after having consumed the 15 kg, the wording “RESERVE” will appear
flashing at intervals. After which the operation must be repeated, from point 1 to point 5.
EMERGENCY BUTTON
If the radio remote control fails you can access the basic functions using a red emergency button located under the outer
door, to the right (see fig 7).
Press the button once or several times to enable the desired function:
1.A STOVE OFF
by pressing the red button for 2 seconds this turns on.
2. A STOVE 54 ON
by pressing the red button for 2 seconds this turns off.
3. A STOVE 54 ON
manual mode, by pressing the red button, you go from P1 to P5.
4. A STOVE 54 ON
automatic mode, by pressing the red button, you go from 5°C to 30°C.
RADIO ANTENNA
The radio signal is received from the radio remote control via a small antenna built into the circuit board.
Kg remaining in tank Kg loaded
INSTRUCTIONS FOR USE
fig. 7
emergency button
… 47 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Edilkamin Kelly at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Edilkamin Kelly in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 8.89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info