Manual Edilkamin Dame (page 10 of 24) (English)

810829

Zoom out

Zoom in

1/24

- 10 -

ENGLISH

A: ue in insulated steel compliant with EN 1856

B: minimum height of 1.5 m and in any case above the height of the

roof gutter

C-E: air intake from inside room (minimum internal section: 80 cm²)

D: steel ue, inside existing brick-built chimney.

SMOKE OUTLET

The stove must have its own smoke outlet (the smoke can-

not be discharged into a smoke ue used by other devices).

The smoke is discharged through the 8 cm diameter outlet at

the back

or top of the stove

The smoke outlet must be connected to outside by means of

suitable steel pipes EN 1856 certied.

The pipe must be hermetically sealed.

An example of a suitable pipe bears the following informa-

tion:T600 N1 D V2 L50050 G70 (not suitable with T < 200; 0

indicating no resistance to the ow of soot).

The material used to seal and if necessary insulate the pipes,

must be resistant to high temperatures (high temperature silico-

ne or mastic).

The only horizontal section allowed may be up to 2 m long up

to three 90° bends (in relation to the vertical).

A vertical section of at least 1.5m and an anti-wind terminal

is necessary (if the discharge outlet is not in a chimney ue -

reference UNI 10683).

The vertical duct can be internal or external.

If the smoke channel is outside, it must be appropriately insu-

lated. If the smoke channel is tted inside a chimney ue, the

latter must be suitable for solid fuel.

If it is wider than 150 mm in diameter it must be improved by

entering a pipe that has a suitable cross-section and is made of

suitable material (e.g. 80 mm diameter steel).

All sections of the smoke duct must be accessible for in-

spection.

The chimney pots and smoke ducts connected to the solid fuel

appliances must be cleaned once a year (verify whether a speci-

c legislation exists in your country).

Failure to regularly inspect and clean the stove increases the

probability of a re occurring in the chimney pot. In that case,

proceed as follows: Do not use water to extinguish the re;

Empty the pellet hopper; Contact specialist personnel before

reigniting the stove.

The stove is designed to work under any weather conditions.

In case of particular conditions, such as strong wind, the safety

system may be activated, which results in the stove being extin-

guished.

If this happens, do not operate the stove with the safety devices

disabled. If the problem persists, contact our Technical Service

Department.

Ø 8 cm uscita fumi

Ø 4 cm aria

combustione

112

INSTALLATION

CHIMNEY POT

The main characteristics are:

- an internal cross-section at the base, which is the same as that

of the chimney ue

- an outlet cross-section which is no smaller than twice that of

the chimney ue

- its position must be high enough to catch the wind and avoid

downdraft areas in turbulent wind, it must be high enough to

catch the wind and avoid downdraft areas in turbulent wind.

TYPICAL EXAMPLES

Fig. 1 Fig. 2

inspection

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Edilkamin Dame in the language / languages: English as an attachment in your email.

The manual is 2.74 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Edilkamin Dame

Edilkamin Dame Usermanual and installation guide - German - 24 pages

Edilkamin Dame Usermanual and installation guide - French, Italian - 44 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Edilkamin Dame Manual

Product: