810907
9
Zoom out
Zoom in
Previous page
1/28
Next page
9
ENGLISH
INSTALLATION
GENERAL NOTES
The smoke discharge and plumbing connec-
tions must be carried out by qualified person-
nel who can issue an installation declaration
of conformity complying with national law.
In Italy it is necessary to refer to the standard declaration
of conformity conforming to Ministerial Decree 37/2008
(pursuant to Law 46/1990) and standards UNI 10683 and
UNI 10412-2/2009.
In the case of installation in a multiple-tenancy building,
contact the building manager before installation.
VERIFY COMPATIBILITY WITH OTHER DEVICES
In Italy the boiler-stove MUST NOT be installed in the same
space as type B gas heating equipment (e.g. gas boilers,
stoves, and equipment served by an extraction hood - ref.
UNI 10683 and 7129).
In general, the stove could create low pressure in the
room, affecting the operation of such appliances or being
affected by them.
VERIFY THE POWER SUPPLY
CONNECTION (the plug must be accessible)
The boiler-stove is supplied with a power cable that is to be
connected to a 230V 50 Hz socket, preferably fitted with a
magnetothermic switch.
The electrical system must comply with the law; particularly
verify the efficiency of the earthing system.
The power line must have a suitable cross-section for the
boiler power.
An inadequate earthing system can cause anomalies for
which Edilkamin cannot be held liable.
In case of problems with the electrical grid, consult an
electrician to evaluate the installation of a sine-wave UPS of
at least 800 Va.
Power variations greater than 10% can cause problems for
the product.
AIR INLET (to be mandatorily implemented)
The room where the boiler-stove is located must have an
air intake with cross section of at least 80cm2 to ensurere-
plenishment
of the air consumed by combustion.
Alternatively, the boiler-stove air may be taken directly from
outside through a 4 cm steel extension of the pipe. In this
case,there may be condensation problems and it is neces-
sary to protect the air intake with a grille, which must have
a freesection of at least 12 cm². The pipe must be less than
1 metre long and have no bends. It must end with section
at 90° facing downwards or be fitted with a wind guard. In
any case all the way air intake duct must be a free section
of at least 12 cm². The external terminal of the air inlet
channel must be protected with an anti-insect netting that
does not reduce the 12 cm² through passage.
POSITIONING AND DISTANCES FOR FIRE SAFETY
For correct operation the boiler-stove must be level.
Check the load-bearing capacity of the floor.
The boiler-stove must be installed in compliance with the
following safety conditions:
- flammability items must be kept at a minimum distance of
10 cm from the sides and back of the boiler-stove
- highly flammable items must be kept at a minimum di-
stance of 80 cm if placed in front of the boiler-stove
- if the boiler-stove is installed on a flammable floor, a sheet
of heat insulating material must be placed between the
boiler-stove and the floor, which protrudes by at least 20
cm at the sides and 40 cm at the front.
Flammable objects must not be placed above the boiler-
stove or at a distance that is any less than the stipulated
safety distances. If connected to wooden walls or other
flammable materials, the smoke exhaust pipe must be
appropriately insulated with ceramic fibre or other similar
material.
INSTALLER
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Edilkamin Daisy at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Edilkamin Daisy in the language / languages: English as an attachment in your email.

The manual is 5.34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Edilkamin Daisy

Edilkamin Daisy Usermanual and installation guide - German - 28 pages

Edilkamin Daisy Usermanual and installation guide - Dutch - 28 pages

Edilkamin Daisy Usermanual and installation guide - French, Italian - 52 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info